Specifications

Vincent

INSTALLATION

Set up the cable links in a sequence as follows. Connect the power cable between device

and power supply only after all other connections have been made.

Protective caps

Prior to the first installation the pro-

tective plastic caps must be removed

from all the connections used at the

rear of the unit.

RCA connections

Mechanically identical RCA

plugs are available for analogue and digital out-

puts. Make sure that you do not get these connec-

tions confused during installation!

Make sure that you do not mix up the analogue con-

nectors for right and left. The RCA plugs for these are

mostly colour coded as follows: red for the right chan-

nel, black or white for the left channel.

OUTPUT

- wrong - - correct -

DURING INSTALLATION PLEASE OBSERVE

THE FOLLOWING ADVICE:

Cable connections

Make sure that all plugs fit tightly. Inadequate con-

nections can cause noise interference, failures and

malfunctions.

Cables

To make the most of the components’ sound

potential, only high quality loudspeakers and

connecting cables, for example Vincent cables,

should be used. Your local stockist will be glad to

advise you about this.

Make sure that the electricity supply to your home is appropriate to the device. The required voltage and fre-

quency can be read on the back of the device beside the socket for the mains. If the electricity supply is appro-

priate, push the inlet connector of the supplied mains cable firmly into socket for the mains on the back of the

device (14). Connect the other end of the mains cable to a mains socket.

CONNECTION OF THE POWER CABLE

A set of headphones equipped with a 6.3 mm jack can be plugged into the “PHONES” socket (33) on the front

of the appliance. All headphones with an impedance of between 32 Ohm and 600 Ohm may be used. Before

plugging-in the volume “LEVEL” should be reduced (34) for safety reasons.

CONNECTING HEADPHONES