Specifications

Vincent

Cable connections

Make sure that all plugs fit tightly. Inadequate con-

nections can cause noise interference, failures and

malfunctions.

To make the most of the components’ sound poten-

tial, only high quality loudspeakers and connecting

cables, for example Vincent cables, should be

used. Your local stockist will be glad to advise you

about this.

Protective caps

Prior to the first installation the protective plastic

caps must be removed from all the connections

used at the rear of the unit.

RCA connections

Mechanically identical RCA plugs are available for

analogue and digital outputs. Make sure that you

do not get these connections confused during

installation!

Make sure that you do not mix up the analogue con-

nectors for right and left. The RCA plugs for these are

mostly colour coded as follows: red for the right

channel, black or white for the left channel.

Contacting the middle pin of the RCA plugs with the

outer ring of the RCA chassis jack may lead to dama-

ges to the main amplifier if it is switched on! To avoid

this hazard, connect or disconnect only in switched-

off state and more than one minute after deactivating!

INSTALLATION

Set up the cable links in a sequence as follows. Connect the power cable between device

and power supply only after all other connections have been made.

DURING INSTALLATION PLEASE OBSERVE

THE FOLLOWING ADVICE:

OUTPUT

- wrong - - correct -