Owners Manual

42
Vincent
Operation Button(s) Description
Switch on and off POWER (4)
The preamplifier is switched on and off using this button at the front panel.
It has no standby option. When switched off the device is internally separa-
ted from the AC power. As a precaution, after switching on, the volume set-
ting (3)(23) of the preamplifier should be reduced.
Select an input
INPUT (1)
Input
selection
keys (17)
At the front panel: If you turn the dial “INPUT”, you select one of the devi-
ces connected to the inputs on the back of the SV-200 (8) for playback.
Using the remote control: A short touch on the button for the desired input
channel (e.g. “S1”) changes to the playback of the audio source connec-
ted there.
The LED associated to the selected input channel will be illuminated at the
front of the appliance. Before switching over the input channel, the volume
(3)(23) should be turned down as a precaution!
Change the volume
VOLUME (3)
VOLUME
p / q (18)
At the front panel: Turn the knob “VOLUME” clockwise to turn up the volu-
me and counter-clockwise to turn it down.
Using the remote control: Press and hold the button “VOLUME p” to raise
its value. Use “VOLUME
q” to lower the volume level.
The volume setting controls the speakers and the signal level at the “PRE OUT”
(10) but does never influence the signal at the output “REC OUT” (9).
Switch on/off the audio
signal correction for low
volume on and off
LOUD (5)
This function is operated from the front panel. It is a feature of audio ampli-
fiers that permits the user to strengthen low and high frequencies compared
with middle frequencies at the touch of a button. It thereby corrects the
impression of volume at low volume. In an audio system, when the volume
is small, low and high frequency ranges are insufficient because of the cha-
racteristic of human auditory sensation. This function should only be used
at low volume. It has no effect on the signal of the recording output “REC
OUT” (9).
OPERATING THE APPLIANCE