Specifications
38
Vincent
Operation Button(s) Description
Switch on and off POWER (6)
The amplifier is switched on and off using this button at the front panel.
When switched off the device is not internally separated from the AC
power and reacts to a signal at the input “POWER CONTROL INPUT”
(15). That is why it is not possible to switch off the amplifier as long as a
12V trigger signal is present at this input. As a precaution, after switching
on, the volume setting should be reduced.
Individually activate or
deactivate speaker
outputs A and B
SPEAKER
A/B (1)
To play back stero music via loudspeakers at least one pair of them must be
attached to the amplifier (a practical choice would be connectors “A“). The
output you use must be activated using the corresponding button "SPEA-
KER" (LED illuminated). Only if a second pair of speakers is used, it is
necessary to activate the second speaker output “B“.
Select an input
Input
Selector
buttons
(5)(22)
A short touch on the button for the desired input channel
(“LINE1”...”LINE6”) changes to the playback of the audio source connec-
ted there. The front panel as well as the remote control carry those buttons.
The name of the currently selected input channel appears in the display.
Before switching over the input channel, the volume (4)(19) should be tur-
ned down as a precaution!
Change the volume
LEVEL
/
(4)
VOLUME
/
(19)
Hold down the button “LEVEL ” or “VOLUME ” to turn the volume up.
Use “LEVEL
” or “VOLUME ” to turn it down. The display (2) shows the
current volume value. The minimum volume value is -99dB, the maximum
volume appears at latest with 00dB, for most speakers much below this
value. The volume value can not be changed if the input “LINE6” has been
selected. In this case the display shows “MAX”. The volume setting does not
influence the signal at the output “OUTPUT REC” (11).
Mute the speakers and
the preamplifier output
MUTE (17)
The MUTE function can only be operated with the remote control. It swit-
ches off the loudspeakers (14), the preamplifier output “OUTPUT PRE” (13)
and the recording output “OUTPUT REC” (11). Pressing it again restores the
volume to its original setting. As long as the amplifier is muted, the display
shows “MUTING”.
OPERATING THE APPLIANCE