Specifications

Vincent

SV-237

e.g. CD player

e.g. main amplifier

power control cable

CONNECTIONS FOR THE STANDBY CONTROL

(POWER CONTROL)

Many devices which can be controlled by a switching signal (not preamplifiers or integrated ampli-

fiers), have two terminals which do not differentiate between input and output. In this case either of

the two can be selected.

“POWER CONTROL” sockets of preamplifiers or integrated amplifiers must not be interconnected!

All receiving devices must not be connected to more than one preamplifier or integrated amplifier

(directly or indirectly)!

ces near the speakers. To employ these functions, direct or indirect cable connections must be made bet-

ween the preamplifier (or integrated amplifier) and all the devices which support this function. The

“POWER CONTROL” function operates in such a way that each switching on or off of one device in the

system (usually the preamplifier) automatically brings about the switching on or off of all the connected

devices which support this function. Please keep in mind that all devices which respond to the power con-

trol are not disconnected from the mains network when switched off. They are set to a standby state inste-

ad. For connecting cables, two-core cables with 3.5 mm jack plugs (mono) are used. For each connecti-

on between two devices one of those cables is needed.

If you don't wish to use this function or if the other components do not support it, all you have to do is

leave out these cable connections.

The SV-237 is equipped with two output connectors for the power control. Here, the switching signal gene-

rated by the amplifier is available for other components of the system. Two HiFi components that are able

to react to the power control signal can be connected directly to the amplifier's power control outputs (16).

If more than two devices, which can be controlled, are to be connected, then it is necessary to make the

power control connection between the amplifier and these further devices through the outputs of the two

devices which are connected directly. For that reason, every HiFi component that accepts power control

signals is also equipped with a power control output. Thus, in theory it is possible to provide an infinite

number of HiFi components with the power control signal. This approach, to loop a signal through a chain

of components, is commonly referred to as “daisy chaining”.

SV-237_05_Bedienungsanleitung 30.01.13 10:01 Seite 34