Specifications

42 Vincent
Frequency response: 20 Hz - 20 kHz ±0.5 dB
Nominal Output Power Class A at 8Ω: 2 x 60 W (RMS)
Nominal Output Power Class AB at 8Ω: 2 x 200 W
Nominal Output Power Class AB at 4Ω: 2 x 400 W
Nominal Output Power Class AB at 2Ω: 2 x 700 W
Input sensitivity: 250 mV
Total Harmonic Distortion: < 0.1% (1 kHz, 1 W)
Signal to Noise Ratio: > 95 dB
Input Impedance: 47 kΩ
AC power connection type: 230 V / 50 Hz
Inputs: 5x RCA stereo, 1x XLR stereo
Outputs: 4x2 speaker connectors accepting 4 speakers,
1x PRE stereo RCA, 1x PRE stereo XLR
2x Power Control (3.5 mm Jack)
Dimensions (W x H x D): 430 x 180 x 530 mm
Weight: 32 kg
Colour: silver / black
TECHNICAL SPECIFICATIONS
SEARCH FOR ERRORS
Symptom Possible Cause Countermeasure
Poor sound quality
The cable connections are not tight, the con-
nectors are dirty or a cable is defective.
A record player has been connected to a line
level input without using a phono preampli-
fier.
Check the cables and cable connections.
Interconnect a phono preamplifier.
The remote control
cannot perform any
functions
No batteries inserted in the remote control,
batteries are not inserted correctly or are
depleted.
The line-of-sight between the remote control
and the unit is obstructed, the range was
exceeded or the hand unit was operated from
a position too far to one side.
The unit is not switched on.
Check and replace the batteries if necessary.
Try to point the remote control at the front of
the unit only when the sight-line is clear,
within a 7-metre distance and, if possible,
facing the unit.
Switch on the unit.
Humming low
frequency noise is
audible, even as
no audio source is
playing back
See section "Net frequency noise" in the chapter "Tips".