Specifications

38 Vincent
Symptom Possible Cause Countermeasure
Poor sound quality
The cable connections are not tight, the con-
nectors are dirty or a cable is defective.
A record player has been connected to a line
level input without using a phono preamplifier.
Check the cables and cable connections.
Interconnect a phono preamplifier.
The remote control
cannot perform any
functions
No batteries inserted in the remote control,
batteries are not inserted correctly or are
depleted.
The line-of-sight between the remote control
and the unit is obstructed, the range was
exceeded or the hand unit was operated from
a position too far to one side.
The unit is not switched on.
Check and replace the batteries if necessary.
Try to point the remote control at the front of
the unit only when the sight-line is clear,
within a 7-metre distance and, if possible,
facing the unit.
Switch on the unit.
Humming low
frequency noise is
audible, even as
no audio source is
playing back
See section "Net frequency noise" in the chapter "Tips".
Frequency response: 20 Hz - 20 kHz ±0.5 dB
Nominal Output Power at 8Ω: 2x 50 W
Input sensitivity: 200 mV
Total Harmonic Distortion: < 0.1 % (1 kHz, 1 W)
Signal to Noise Ratio: > 90 dB
Input Impedance: 47 kΩ
AC power connection type: 230 V/50 Hz
Inputs: 5x RCA stereo, 1x USB
Outputs: 2 stereo loudspeaker sockets, 1x PRE stereo RCA,
1x REC stereo RCA
Dimensions: 430 x 98 x 335 mm
Weight: 9,5 kg
Colour: silver / black
TECHNICAL SPECIFICATIONS
38 Vincent
SV-400 korr_2_Bedienungsanleitung 13.09.11 13:26 Seite 38