Owners Manual

Vincent

CONNECTION OF THE POWER CABLE

Check that the electricity supply to your home is appropriate to the device. The required voltage and fre-

quency can be read on the back of the device beside the socket for the mains. If the electricity supply is

appropriate, push the inlet connector of the supplied mains cable firmly into socket for the mains on the

back of the device. Connect the other end of the mains cable to a mains socket.

A set of headphones equipped with a 6.3 mm jack can be plugged into the socket “PHONES” (3) on the

front of the appliance.

By doing this, the loudspeakers are switched off. All headphones with an impedance of between 32 Ohm

and 600 Ohm may be used. Unsuitable headphones with too low impedance may damage the amplifier

or produce such unexpectedly loud volume that your hearing may be damaged. The volume (8)(21) should

be reduced for safety reasons before a set of phones is connected.

CONNECTION OF HEADPHONES

SV-500

If no connector is to be used, remove approxima-

tely 1 cm length of insulation from each end of the

speaker wire. Twist the braid in order to avoid

short circuits. Turn the fastener on the loudspeaker

terminal counter clockwise to loosen it and introdu-

ce the bare wire end into the exposed connector

hole. Then turn the fastener clockwise so that the

wire is firmly clamped. Make sure the connection

is pretty tight.

CONNECTION OF THE LOUDSPEAKERS

SWITCHING THE VOLTAGE

This device is equipped with a switch (16) that can be used to change the country-specific voltage from

230 V to 110 V.

Please never actuate the switch during operation! The voltage must only be switched by a techni-

cian, since the device fuse must also be replaced after actuation of the switch! Information about

the device fuse can be found on the back of the device.

Unauthorised actuation of the switch will void any warranty claim!