User's Manual

10. Refer all servicing to qualified service personal. Servicing is required when the apparatus has

been damage in any way, for example, when the power-supply cord or plug is damaged, liquid has

been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or

moisture, does not operate normally, or has been dropped.

11. The AC plug is used to disconnect the device, the disconnected device should remain readily

operable. In order to disconnect the apparatus from the AC power completely, the AC plug must be

removed from the AC outlet completely.

Preparation for Use

Unpacking and Set Up

•Remove the Sound bar from the carton and remove all packing material from the Sound bar. Save

the packing material, if possible, in case the Sound bar ever needs to be serviced or transported.

The original carton and packing material is the only safe way to pack your Sound bar to protect it

from damage in transit.

•Remove any descriptive labels or stickers on the front or top of the cabinet. Do not remove any

labels or stickers from the back or bottom of the cabinet.

•Place your Sound bar on a level surface such as a table, desk or shelf, convenient to an AC outlet,

out of direct sunlight, and away from sources of excess heat, dirt, dust, moisture, humidity, or

vibration.

•Unwind the Line cord connecting the AC adapter and extend it to its full length.

Protect Your Furniture

This model is equipped with non-skid rubber 'feet' to prevent the product from moving when you

operate the controls. These 'feet' are made from non-migrating rubber material specially formulated

to avoid leaving any marks or stains on your furniture. However certain types of oil based furniture

polishes, wood preservatives, or cleaning sprays may cause the rubber 'feet' to soften, and leave

marks or a rubber residue on the furniture. To prevent any damage to your furniture we strongly

recommend that you purchase small self-adhesive felt pads, available at hardware stores and home

improvement center everywhere, and apply these pads to the bottom of the rubber 'feet' before you

place the unit.

Power Source

This sound bar is designed to operate on normal AC Power source. For Europe, it works only under

SMPS 110V-240V～50hz/60Hz. Do not attempt to operate the Sound bar on any other power

source. You could cause damage to the Sound bar that is not covered by your warranty.