Owner`s manual

Wood Wine Cabinet Owner’s Manual
VINOTEMP.COM
9
back of the rack. Remove the entire rack. Note: The bar must be removed prior
to removing the rack on models with horizontal support bar (models 440 single
door and 440E single door).
7. Carefully tilt the cabinet back and place on the cardboard packing or padding to
avoid damaging the cabinet.
8. With the 4mm wrench, carefully remove bolts on the side of the cabinet and
place the side panel on the cardboard.
9. Having someone hold the top and bottom ends, remove bolts on the other side.
Place the side panel on the cardboard.
10. Remove the bolts at the top of the cabinet. Place on top of the cardboard.
ASSEMBLY INSTRUCTIONS
1. Install the casters all the way in on the bottom piece first.
2. To assemble your unit, follow the disassembly instructions in reverse.
3. If doors appear unaligned, level the cabinet as best possible by screwing the
casters back out slowly, checking alignment with each adjustment.
4. Allow 5 to 6 inches of clearance from the back of the wine cabinet to the wall to
allow for proper air circulation.
5. Your cabinet is now ready to plug into a dedicated 115V outlet. It is
recommended that a separate circuit serving only your wine cabinet be provided.
Do not plug your cabinet into an outlet used for other electronic items.
Note: Vinotemp applies an insulation tape in the panel joints of the cabinet that may be
glue-like in appearance. If the insulation tape is damaged it should be replaced.