Manualshelf

Owner`s manual

ManualsBrandsVinotemp ManualsKitchen Appliances1500CD
21222324252627282930
Wood Wine Cabinet Owner’s Manual
20
VINOTEMP.COM
HOW TO VIEW/SET THE DESIRED TEMPERATURE OR “SET POINT”:
To view the current set point value: Push and immediately release the SET key. The
display will show the value. Wait 5 seconds or push SET again to return to the previous
display.
To change the set point value: Press and hold the SET key until the “C” or “F” indicator
light starts blinking. You are now in programming mode and have 10 seconds to begin
adjusting the desired temperature. Use the UP or DOWN button to adjust the value,
then press SET again or wait 10 seconds to save the new desired temperature.
NOTE: The unit turns on at set-point Set plus regulation differential H y after anti-short
cycle A C has elapsed; the unit turns off at set-point Set.
HOW TO ADJUST THE HUMIDITY:
The parameter Fon is used to adjust the humidity in the wine cabinet. Higher Fon
results in higher relative humidity. Use a separate hygrometer to monitor the humidity of
your cabinet.
MANUAL DEFROST:
To manually start the defrost cycle: Push and hold the DEF key for at least two
seconds. Note: By default the cooling system will defrost once every 24 hours.
ALARM CODES
The Wine-Mate digital control panel features an LED alarm indicator that will turn on
when triggered. In addition, the control panel will display the following codes:
MESSAGE
C AU S E
FUNCTION
P1
Temperature probe fault
Compressor switching to Con and CoF
HA
High temperature alarm
Probe temperature ALU higher than
the setting temperature; outputs
unchanged
LA
Low temperature alarm
Probe temperature ALL lower than the
setting temperature; outputs
unchanged
CA
External alarm
All outputs off
ALARM RECOVERY
Probe alarm “P1” starts a few seconds after the fault in the related probe and stops a
few seconds after the probe restarts normal operation. Check connections before
replacing the probe. Temperature alarms “HA” and “LA” automatically stop as soon as
the temperature returns to normal. Alarm “CA” (with i1F=PAL) recovers only by
switching the unit off and then on again.