Owner`s manual

Wood Wine Cabinet Owner’s Manual
VINOTEMP.COM
7
WINE CABINET INSTALLATION
MOVING THE CABINET
It is okay to tip the wine cabinet forward, backwards, or on its side in order to get it
through doorways during installation. Never push, pull, or lift the cabinet by its doors or
handles when moving. It may be necessary to remove the cabinet doors during
installation to fit it through doorways. Please refer to Cabinet Disassembly/Reassembly
on page 8 for more detailed instructions.
ALIGNING YOUR CABINET
Vinotemp cabinets are equipped with legs which can be adjusted up or down with a
wrench as needed to align the unit. There are two primary reasons for alignment:
1. Assure the unit stands solidly on the floor without rocking back and forth.
2. To adjust the doors and assure that they are flush and provide a tight seal.
Alignment should only be done once the cabinet is in its permanent location and prior to
filling it with wine bottles.
To align the cabinet, slowly turn the legs clockwise using a wrench. It may require you
to make several complete rotations
around the unit in order to
complete the needed adjustments.
Do not attempt to level the cabinet
with a leveling device. Proper
alignment requires only that the
doors are flush and sealing
properly and that all of the legs
of the unit are touching the
ground. If the doors are not
properly sealed it will allow cool air
to escape and your cooling system
will not perform to its best ability.
IMPORTANT:
Adjustment of the
legs for proper
alignment is the
customer’s
responsibility.