Owner`s manual

Wood Wine Cabinet Owner’s Manual
8
VINOTEMP.COM
CABINET DISASSEMBLY/REASSEMBLY
DISASSEMBLY INSTRUCTIONS
1. Top Panel
2. Door(s)
3. Right Panel
4. Bottom Panel
5. Foot
6. Screws (used for #7)
7. Bottom Metal
8. Screws (used for panels)
9. Hinge(s)
10. Rear Panel
11. Left Panel
Tools required for disassembly:
• 7/16” wrench
• Phillips screwdriver
• 4mm hex wrench (Allen
wrench)
• ¼” nut driver
Note: 2-3 people are required to
complete cabinet disassembly.
Remove racking first. Also, some
units are equipped with a horizontal
stabilizing bar which must be
removed first.
1. Remove shipping carton and packing material with the exception of the pallet.
Open door and remove the plastic bag containing four or six casters depending
on the size of the unit.
2. Place the cardboard on the ground behind the wine cabinet.
3. With the 7/16” wrench, remove the three bolts at the top of the cooling unit.
Carefully slide the unit out and place it on the ground out of the way in an upright
position. Be careful not to damage the insulated bottom.
4. Some 700 series cabinets include a vertical bar. Remove the vertical middle bar
by removing the center screw in back brace, then remove screws on top and
bottom of middle bar.
5. Carefully remove the screws that are on the cabinet side of the hinge making
sure someone is holding the door while screws are being removed. Place the
door on the cardboard to the side of the wine cabinet.
6. With the Phillips screwdriver or ¼” nut driver, carefully remove the screws
holding the bottle racks; be sure to save the screws which are located in the top