Use and Care Manual

13
732 Sout h Race t rac k R oad , H end erson, N evada 89015
i n f o @ v i n o t e m p . c o m
Operating Your Wine Cooler
The Wine cooler should be placed in a position where the ambient temperature is
between -38
°C
/41-100
°F
. Humidity level is between 45~90%. If the position is
above or below this range, the performance of the unit may be affected. For example,
placing your unit in extreme cold or hot conditions may cause interior temperature to
fluctuate.
NOTE:
 When you use the wine cooler for the first time or restart the w
ine cooler after
having been shut off for a long time, there could be a few degrees variance
between the temperature you select and the one indicated on the LED readout .
This is normal and it is due to the length of the activation time. Once the wine
cooler is running for a few hours everything will be back to normal.
 If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes
before restarting the unit. If you attempt to restart before this time delay, the wine
coo
ler will not start.
The controls of your wine cooler
Up
Used to raise (warm)the set temperature by 1
°C
or 1
°F
.
Temperature Display
°C
/
°F
Display
Down
Used to lower (cool) the set temperature by 1
°C
or 1
°F
.
Set temperature
press this bottom,
to set temperature.
view the SET and
temperature in at any time.
the “SET” on SET temperature will temporarily “flash” in the LC D
display for 5 seconds
The DISPLAY temperature
°F /°C Selector
Select the temperature display setting in Fahrenheit or Celsius degree.
5
DISPLAY
shows you the current temperature of your wine cooler.
or
.
You can
2
3
5
6
4
7
Backlight Used to turn on/off the backlight.
1
1
2
3
4
5
6
Within 5 seconds, you can press