Use and Care Manual

ASSEMBLY INSTRUCTIONS

CELLAR TRELLIS WINE RACK

17631 S.Susana Road | Rancho Dominguez | CA | 90221 | www.vinotemp.com

1.800.777.8466 | Fax: 310.866.3310

Step 1: Lay out vertical strips with notches.

Step 2: Insert horizontal strips into vertical strips.

Step 3: Insert dowels at one end of the rack to hold

rack steady.

Step 4: Insert dowels at the other end of the rack

and insert rest of horizontal strips by bisecting the

rack. Insert dowels through center of rack (this

keeps strips from coming out of the notches.)

Install remaining dowels, working from center of

the rack towards the outside.

PAGE 1
ASSEMBLY INSTRUCTIONS CELLAR TRELLIS WINE RACK Step 1: Lay out vertical strips with notches. Step 2: Insert horizontal strips into vertical strips. Step 3: Insert dowels at one end of the rack to hold rack steady. Step 4: Insert dowels at the other end of the rack and insert rest of horizontal strips by bisecting the rack. Insert dowels through center of rack (this keeps strips from coming out of the notches.) Install remaining dowels, working from center of the rack towards the outside. 17631 S.
PAGE 2
ASSEMBLY INSTRUCTIONS CELLAR TRELLIS WINE RACK Step 5: Place vertical strips on dowels. Step 6: Place horizontal strips over vertical strips. Step 7: Place nails in all four corners; tap lightly with hammer. (Do not drive nails around perimeter of rack.) This holds strips in place and holes aligned. Starting at the center of rack, place remainder of nails in holes; tap lightly with hammer. After all nails are in place, start at center of rack and drive in the nails completely.