EL-54BCCOMM-L SINGLE-ZONE BEVERAGE COOLER 732 South Racetrack Road, Henderson, NV 89015 | 1.800.777.8466 | info@vinotemp.com | www.vinotemp.
YOUR BEVERAGE COOLER This unit can be used for storage and/or service. The unit has a glass door and soft interior light that you can use to display your beverages or even wine. SERVING BEVERAGES Storing beverages at the proper temperature is important. To preserve them as long as possible beverages should be stored at approximately 39° Fahrenheit. However, the chart below suggests the optimal drinking temperature for the different styles of beverages.
GENERAL OPERATING INSTRUCTIONS Remove all external and internal packaging from your appliance. Be sure that all parts have been included before discarding any packaging materials. You may want to keep the box and packing materials for use at a later date. Upon receipt and inspection of unit, the supply cord must be replaced if it is damaged. Contact our customer service at 1-800-777-8466 or info@vinotemp.com. Let the unit rest UNPLUGGED for 24 hours once you have it placed in your home.
TABLE OF CONTENTS IMPORTANT SAFETY INSTRUCTIONS ..................................................................... 5 ELECTRICAL CONNECTION ...................................................................................... 6 PARTS AND SPECIFICATIONS ................................................................................. 7 BOTTLE CAPACITY .................................................................................................... 8 INSTALLATION ........................................
IMPORTANT SAFETY INSTRUCTIONS • • • • • • • • • • • • • • • • • • • • • • Do not operate this or any other appliance with a damaged cord. Do not operate if housing is removed or damaged. Exercise caution and use reasonable supervision when appliance is used near children. Never allow children to operate, play with or crawl inside the appliance. Keep packing materials away from children.
ELECTRICAL CONNECTION For your protection, this unit is equipped with a 3-conductor cord set that has a molded 3-prong grounding-type plug, and should be used in combination with a properly connected groundingtype outlet. • Do not under any circumstances cut or remove the third ground prong from the power cord supplied. For personal safety, this appliance must be properly grounded. • The cord should be secured behind the unit and not left exposed or dangling to prevent accidental injury.
PARTS AND SPECIFICATIONS ① Cabinet ② Full glass door ③ Stainless steel handle ④ Ventilator ⑤ Leveling legs ⑥ Control panel ⑦ Glass shelves ⑧ Lock Model EL-54BCCOMM-L Voltage 115V Frequency 60Hz Ambient Temp Range 41-100°F / Humidity 45-90% Control Temp Range 34-64°F Refrigerant R600a/1.23Oz Power Consumption 0.6kWh/24h Input Power 200W Volume 5.3 cu.ft. Net Weight 115 lbs Gross Weight 121 lbs Dimensions (WxDxH) 23.4inx23.4inx34.3in Box Dimensions (WxDxH) 25.3inx26inx35.
INSTALLATION Remove all packing material before using your beverage cooler. IMPORTANT: Before connecting the unit to a power source, let it stand upright for approximately 24 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation. This unit is designed for freestanding or built in installation but indoor use only. Position the unit in a dry and well-ventilated place.
INSTALLING THE STAINLESS STEEL HANDLE This beverage cooler includes a stainless steel handle that is not required to operate this unit. To install the handle please follow the below instructions: ① Pull away the door gasket in the area where the handle is to be installed. You can see two designated holes for handle installation. The gasket is easily displaced by hand, no tools are necessary. ② Install the handle tightly as shown below with the two screws, lock washers and flat washers provided.
The controls of your beverage cooler ① Up Used to raise (warm) the set temperature by 1°C or 1°F. ② Temperature Display ③°C/°F Display ④ Down Used to lower (cool) the set temperature by 1°C or 1°F. ⑤ Set Temperature Press this button, and the UP or DOWN mark to set the temperature. Touch the UP or DOWN mark to view the “set” temperature at any time. The “set” temperature will temporarily “flash” in the LED display for 5 seconds.
SETTING THE TEMPERATURE CONTROL You can select the temperature display setting from Fahrenheit to Celsius degrees by touching the °C/°F Selector mark. The Fahrenheit or Celsius degree indicator will appear in blue color in the temperature display window. You can set the desired temperature by touching the UP and DOWN marks. When you touch the two marks for the first time, the LED readout will show the original temperature set previously.
CARE AND MAINTENANCE CLEANING YOUR BEVERAGE COOLER IMPORTANT: Always unplug the unit before cleaning or performing maintenance. Never use harsh cleansers or scouring pads to clean any part of the unit. • Turn off the power, unplug the appliance, and remove all items including shelves. • Wash the inside surfaces with a warm water and baking soda solution. The solution should be about 2 tablespoons of baking soda to a quart of water. • Wash the shelves with a mild detergent solution.
PROBLEMS WITH YOUR BEVERAGE COOLER Most common problems can be solved easily, saving you the cost of a possible service call. Try the following suggestions to see if you can solve the problem before contacting Vinotemp at Info@Vinotemp.com. TROUBLESHOOTING PROBLEM POSSIBLE CAUSE • • • Ensure unit is plugged into an electrical outlet. Check if unit is turned off. Check for a tripped circuit breaker or blown fuse. • • • • Check the temperature control setting.
Terms of Sale Shipping/Delivery fees are the responsibility of the Purchaser. Seller is not responsible for the carrier’s missed/Non delivery for any reason. Delivery is curbside. Optional upgrades in delivery service is an additional fee. If upgraded delivery service cannot be performed properly, Purchaser agrees to accept delivery curbside and the difference in upgraded cost will not be refunded.
have original and/or proper packaging. Swap-outs (Delivery and Pick up are at the same time) Original unit must be packed and ready for carrier pick up at time of delivery of new unit. Packaging of old unit must be adequate for shipping, not oversized or on a pallet if unit was not originally delivered on a pallet. Carrier will not drop off new unit if the original unit is not ready.
OPEN AND INSPECT YOUR DELIVERY. When FOB Destination, if the item is damaged by the freight company, and Purchaser cancels rather than accepts a replacement, the order can be cancelled by paying for freight costs both ways and a 35% restocking fee for stocked items. No cancellation or refunds on custom/made or made to order products. When shipped 3rd Party (FOB Warehouse), Purchaser assumes all responsibility for delivery, payment of freight and freight claims for damages during shipment.
Wine Accessories, Racking Systems, Parts and Other miscellaneous items is a 30 day warranty. Il Romanzo units: Warranty 90 (ninety) days. Replacement part 12 (twelve) months from the date of sale. Brama: 1 year warranty from date of purchase. Non-New Units (Scratch & Dent/Refurbished/Floor Models), warranty for compressor units is 90 days from your dated invoice and 30 days for thermoelectric units (parts for function only, not cosmetic defects).
Storage Fees: When having an item serviced by a Vinotemp service technician at the Vinotemp facility, Purchaser agrees to pick up their repaired item or make arrangements for return shipping within a 30 day period once they have been notified by Vinotemp through phone call, email, or letter that their unit is ready for pick up. If the item remains in the Vinotemp warehouse after 30 days but no longer than 60 days, the Purchaser will incur additional storage fees of 2%.
We each agree that any dispute resolution proceedings will be conducted only on an individual basis and not in a class, consolidated or representative action. If for any reason a claim proceeds in court rather than in arbitration we each waive any right to a jury trial. Both parties agree to bring suit in court to enjoin infringement or other misuse of intellectual property rights.
4. LIMITED WARRANTY on Non-New Units (Scratch & Dent/Refurbished and Floor Models): warranty for compressor units is 90 days from your dated invoice and 30 days for thermoelectric units (parts for function only, not cosmetic defects). These units are refurbished and sold as is; Purchaser assumes risks to the quality and performance of goods and assumes the costs of all necessary service or repair not covered herein. Wine Accessories, Racking Systems and other items not mentioned are not warranted.
9. In the event of any dispute between Seller and Purchaser arising out of or relating to these terms and conditions or to the goods sold generally, Purchaser must first file a written claim with Seller within thirty days of the occurrence giving arise to the claim and wait an additional thirty days for a response before initiating any legal action.
SERVICE & IMPORTANT NOTICE Upon receipt and inspection of unit, the supply cord must be replaced if it is damaged. Contact our customer service at 1-800-777-8466 or info@vinotemp.com. The manufacturer has a policy of continuous improvement on its products and reserves the right to change materials and specifications without notice. WARNING: Please do not place the unit within reach of children. For adult use only. Contact info@vinotemp.com with any questions or visit www.vinotemp.com 732 S.