Owner's Manual

1
0
10
W W W . V I N O T E M P . C O M
DYNAMIC COOLING/SILENT MODES
The Dynamic Cooling feature enables the relative humidity inside the unit and the temperature to
be distributed evenly around the interior so you can store all of your wine under the exact same
excellent conditions. If you would like to use the unit to store wine long term, the dynamic cooling is
a must. This will create a continuous climate in the cabinet which imitates that of a wine cellar.
In the Dynamic cooling mode, the interior fan circulates the inside air evenly until the set
temperature is reached. Dynamic Cooling is the factory preset mode. To change to Silent mode,
touch and hold the UP button for approximately five seconds. The wine cooler will beep three times
to confirm silent mode is on. To change back to Dynamic Cooling mode, touch and hold the DOWN
button for five seconds. The wine cooler will beep five times to confirm Dynamic Cooling mode is
on.
STORING WINE
You can place 70 standard bottles in the upper zone with 10 bottles on
each shelf and 72 standard bottles in the lower zone with 10 bottles on
each full size shelf and 6 bottles on each half-size shelf. Approximate wine
cooler capacity is 142 bottles.
Note: Bottle capacities are approximate maximums when storing traditional
Bordeaux 750 ML bottles and may include bulk storage. Many bottles differ
in size and dimensions. As such, the actual number of bottles you may be
able to store may vary.
SHELVES
To avoid damaging the door gasket, ensure that the door is fully
opened when pulling the shelves out of the rail compartment.
 The pull-out shelves allow bottles of wine to be viewed
and removed more easily. Any of the extension shelves
can be removed to store larger bottles.
 For easy access to the storage bottles, you must pull the
shelf approximately ⅓ out of the rail compartment. This
unit was designed with metal stop posts on each side of
the shelf track to prevent bottles from falling.
 When removing a shelf from the rail compartment, make
sure to remove all items first. Then move the shelf to the
position such that one of the metal stop post is in the
center of the hole and pull up. Repeat this step with each
of the metal stop posts until the shelf can be removed
from the sliding track.
DISPLAY RACK
5 wine bottles can be arranged on the display rack for wine
presentation. To install the display rack:
 Remove the shelf directly above the shelf you want to put
the display rack on. (Note: Display rack cannot be put on
the top shelf or the shelf directly below control panel.)
 Pull out the shelf where the display rack will be placed.
Place the display rack on it.
 Align metal hooks of display rack with the wine shelf.
10 Bottle Arrangement
6 Bottle Arrangement