Owner's Manual
9
1 7 6 2 1 S o u t h S u s a n a R o a d , R a n c h o D o m i n g u e z , C a l i f o r n i a 9 0 2 2 1
i n f o @ v i n o t e m p . c o m
ºF/ºC Selector
Choose to display temperature setting in Fahrenheit or Celsius. To change the temperature display from
Fahrenheit to Celsius or from Celsius to Fahrenheit, touch and hold for 5 seconds.
Key Lock
After 2 minutes of inactivity, the controls will be locked automatically. To release the lock, touch the and
at the same time for 5 seconds.
TEMPERATURE ZONES
The wine cooler has two temperature zones with a temperature range of 40°-72°F. The recommended
temperature setting for each zone is:
Lower Zone between 55°-72°F (Ideal for red and white wines)*
Upper Zone between 40°-55°F (Ideal for sparkling and white wines)*
*When looking at the temperature zone indicators on your cooler’s control panel, please make sure to match the white squares in the
manual to the white squares on the cooler (For example, the display screen that depicts the white square below the black one
corresponds to the lower temperature zone).
NOTE: The temperature set for the Lower Zone must always be the same or higher than the
temperature set for the Upper Zone. For optimal performance, the set temperature of the two zones
should differ by at least 4°F. It is also normal for the temperature of the air inside the unit fluctuate by
plus/minus 7˚ F. If it fluctuates any more than 7˚ F, please contact customer service.
SETTING A TEMPERATURE
Touch SET to set the internal temperature for each zone. The degrees indicators will appear in the
display window marked for UPPER ZONE and for LOWER ZONE.
When you touch SET for the first time, the LED readouts will show the original temperature settings
(preset factory setting for UPPER ZONE is 10ºC / 50ºF and for LOWER ZONE is 16ºC / 60ºF).
Touch SET once. The left LED indicator for UPPER ZONE will flash. Then touch UP or DOWN to
set the desired temperature.
When you touch SET again, the right LED indicator for LOWER ZONE will flash. Then proceed to touch
the UP or DOWN to set the desired temperature for the LOWER ZONE.
The temperature will increase by 1°C or 1ºF if you touch UP once, or the temperature will decrease by
1°C or 1ºF if you touch DOWN once.
To view the set temperature in either zone at any time, touch UP or DOWN and the set temperature
will temporarily flash in the LED display for 5 seconds. You can touch SET to view the temperature
setting from one zone to the second zone.
NOTE: When using the unit for the first time or after a long period of inactivity, there may be a variance of a
few degrees between the selected temperature and the temperature indicated on the LED readout. This is
normal due to the length of inactivity, and will correct itself after the unit is run for a few hours. If the unit is
unplugged, has lost power or is turned off, wait 3 to 5 minutes before restarting the unit. The unit will not
restart before this time delay.