Installation Guide

19
17621 South Susana Road, Rancho Dominguez, California 90221
[e-mail]
• The appliance is not properly
leveled.
fluctuations. It is due to the
contraction and expansion of the
interior walls.
• Level the appliance with the
adjustable feet.
The door will
not close
properly.
• The appliance is not properly level.
• The door was reversed and not
properly installed.
• The gasket is dirty.
• The shelves are out of position.
• Level the appliance with the
adjustable feet.
• Check the door hinge and
reassemble correctly.
• Clean the door gasket.
• Check the shelves and refit
correctly.
Display “E1”,
“E2” or “E7”.
• “E1”or “E2” indicates the air
temperature sensor has failed.
• “E7” indicates a door switch failure.
• Call for service.
The alarm
sounds and
the
temperature
display
flashes.
Has the appliance door been open for
longer than 60 seconds? If not, then
the temperature has risen higher or
fallen lower than the temperature that
has been set. This could be due to:
• The appliance door being opened too
often.
• The ventilation opening being
covered or too dusty.
• A lengthy interruption to the power
supply.
• A large amount of bottles has been
added to the unit.
If yes, close the door.
• Do not open the door more often
than necessary.
• Clear the obstructions and clean
the dust.
• Leave the appliance to work for a
while until the set temperature has
been reached.
The icon “--”
is lit and
flashing in
the
temperature
display.
• The display temperature is out of
range.
• Only temperatures within the
range 0~99°F/-9~37°C can be
displayed. If the temperature is not
within this range, the icon “--” will
be displayed instead. This is
normal.