A PROUD HERITAGE OF EXPERIENCE & QUALITY 2 Drawer Wine & Beverage Cooler VT-DRAW2WBC O W N E R ’ S M A N U A L W W W . V I N O T E M P .
General Operating Instructions Remove all external and internal packaging from your wine and beverage cooler. Be sure that all parts have been included before discarding any packaging materials. You may want to keep the box and packing materials for use at a later date. Upon receipt and inspection of unit, the supply cord must be replaced if it is damaged. Contact our customer service at 1-800-777-8466 or info@vinotemp.com.
TABLE OF CONTENTS PARTS AND SPECIFICATIONS ............................................... 4 IMPORTANT SAFETY INSTRUCTIONS ..................................... 5 CORD INSTRUCTIONS ......................................................... 6 BEVERAGE COOLER INSTALLATION ....................................... 6 DISPLAY PANEL .................................................................. 7 TEMPERATURE CONTROL ..................................................... 8 CARE AND MAINTENANCE ....................
PARTS AND SPECIFICATIONS 1. 2. 3. 4. Upper door handle Upper door Temperature switch Upper zone temperature control 5. Temperature display 6. Lower zone temperature control 7. Light On/Off switch 8. 9. 10. 11. 12. 13. 14. 15. 16.
IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should be followed to reduce the risk of fire, electric shock, and personal injury. 1. Use this appliance only as described in this manual. Other uses are not recommended and may cause fire, electric shock or injury. 2. This product is intended for indoor, household use. 3. To protect against electric shock, do not immerse unit, plug or cord in water or other liquids. Avoid locating the unit in moist areas. 4.
CORD INSTRUCTIONS For your protection, this unit should be properly grounded. Unit is equipped with a 3-conductor cord set that has a molded 3-prong groundingtype plug, and should be used in combination with a properly connected grounding-type outlet as shown in figure A. It is not recommended to use this beverage cooler with an extension cord or power board. Please ensure that the appliance is plugged directly into the electrical outlet.
DISPLAY PANEL On the display panel in middle of the control panel, you can read the following information and adjust the temperature setting according to your condition: 1. Indicator of the whole unit’s working status. 2. Indicator of the lower zone’s working status: ※: Refrigerating. ○: Maintaining the current temperature. : Heating. 3. Setting temperature of lower zone. 4. Celsius or Fahrenheit degree. 5. The current temperature of the lower zone. 6. Celsius or Fahrenheit degree. 7. Lower zone. 8.
TEMPERATURE CONTROL To control the upper zone temperature, use the UP and DOWN buttons on the left side to adjust the temperature by 1° increments To control the lower zone temperature, press UP and DOWN button on the right side to adjust the temperature by 1° increments. To turn on or off the internal LED lighting, press LIGHT button on the right side. To switch the temperature display from Celsius Degree to Fahrenheit Degree or vice versa, press C/F button.
CARE AND MAINTENANCE Always unplug the cooler and remove any beverage containers before cleaning. Do not use benzene, scrubbing brushes or chemical cleaners as these will damage the unit. Use only a mild, nonabrasive cleanser to clean the exterior of the cabinet. Wash the inside with a warm water and baking soda solution. The solution should be about 2 tablespoons of baking soda to a quart of water. The exterior of the cooler should be cleaned with mild detergent and warm water.
TROUBLESHOOTING GUIDE You can solve many common cooler problems easily, saving you the cost of a service call. Try the suggestions below to see if you can solve the problem before contacting Vinotemp at info@vinotemp.com. PROBLEM Unit does not operate Unit is not cold enough Unit is not plugged in or you may be using a different voltage. The circuit breaker may be tripped or a fuse may be blown. Check the temperature control setting. External environment may require a higher setting.
TERMS OF SALE AND WARRANTY Vinotemp International (“Seller”) and the person or entity that acquires these goods from Seller (“Purchaser”) hereby fully agree to the following terms and conditions of the sale: Shipping fees are the responsibility of the Purchaser whether freight prepaid or freight collect.
SERVICE & IMPORTANT NOTICE Upon receipt and inspection of unit, the supply cord must be replaced if it is damaged. Contact our customer service at 1-800-777-8466 or info@vinotemp.com. The manufacturer has a policy of continuous improvement on its products and reserves the right to change materials and specifications without notice. WARNING: Please do not place the unit within reach of children. For adult use only. Contact info@vinotemp.com with any questions or visit: www.vinotemp.com 17621 S.