Use and Care Manual

ManualsBrandsVinotemp ManualsFreezer44 lbs. Automatic Undercounter Ice Maker in Stainless Steel

W W W . V I N O T E M P . C O M

A P R O U D H E R I T A G E O F E X P E R I E N C E & Q U A L I T Y

O W N E R ’ S M A N U A L

A U T O M A T I C I C E M A K E R

VT- I C E M A K E R 1 5

Summary of content (16 pages)

PAGE 1
A PROUD HERITAGE OF EXPERIENCE & QUALITY AUTOMATIC ICE MAKER VT-ICEMAKER15 O W N E R ’ S M A N U A L W W W . V I N O T E M P .
PAGE 2
General Operating Instructions Remove all external and internal packaging from your appliance. Be sure that all parts have been included before discarding any packaging materials. You may want to keep the box and packing materials for use at a later date. Upon receipt and inspection of unit, the supply cord must be replaced if it is damaged. Contact our customer service at 1-800-777-8466 or info@vinotemp.com. READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE -Save these instructions- 2 W W W .
PAGE 3
TABLE OF CONTENTS IMPORTANT SAFETY INSTRUCTIONS .............................................. 4 PARTS AND SPECIFICATIONS ........................................................ 5 TECHNICAL DATA ........................................................................ 6 ELECTRICAL CONNECTION ............................................................ 6 CORD INSTRUCTIONS .................................................................. 6 INSTALLATION INSTRUCTIONS............................................
PAGE 4
IMPORTANT SAFETY INSTRUCTIONS To reduce the risk of fire, electrical shock or injury when using your appliance, follow these basic precautions:                      4 Do not operate this or any other appliance with a damaged cord. Always unplug the appliance or disconnect power and shut off the water line before cleaning or performing maintenance. Do not run cord over carpeting or other heat insulators and do not cover cord. Keep cord away from high traffic areas.
PAGE 5
PARTS AND SPECIFICATIONS 17621 South Susana Road, Rancho Dominguez, California 90221 info@vinotemp.
PAGE 6
TECHNICAL DATA Model No. VT-ICEMAKER15 Voltage Frequency Rated Current (Ice Making/Harvest) Power Input Power Consumption (kWh/100lbs ice) Refrigerant Ambient Temperature Range Operating Water Temperature Range Maximum Ice Storage Ice Making Capacity (24 hours) Ice Cube Dimensions Approx. Net Weight Approx. Dimensions with feet (W x D x H) Approx. Dimensions with casters (W x D x H)  AC 115V 60 Hz 3.7A/4.8A 260W 13.2 R134a, 7.06oz 45°- 110° F 41°- 90° F 25 lbs Approx. 44 lbs 0.75" x 0.
PAGE 7
INSTALLATION INSTRUCTIONS Before Using Your Ice Maker   Remove all exterior and interior packing material. Check to be sure that the appliance is in good condition and that the following parts are included:  1 Ice scoop  1 Ice storage bin  5 ft. Drain hose  9 ft. Water supply hose  1 Instruction manual  Before connecting the ice maker to the power source, let the unit stand upright for 24 hours. This will reduce the possibility of malfunction in the cooling system from transportation.
PAGE 8
Connecting the water supply IMPORTANT: Improper water line connection may result in flooding. Professional installation is recommended. Review state and local plumbing codes before installation.      The ice maker requires a continuous water supply with a minimum pressure of 15 psig and a static pressure not to exceed 80 psig. The temperature of the water feeding into the ice maker should be between 41°F and 90°F for proper operation. Deionized water is not recommended for use with this unit.
PAGE 9
OPERATING YOUR ICE MAKER IMPORTANT: Although the unit has been tested and cleaned at the factory, due to long-term transit and storage, the first batch of cubes must be discarded. Control Panel Buttons and LEDS  ON/OFF button Pressing the ON/OFF button alternates between turning the ice maker on and off.  MODE button Pressing the MODE button alternates modes between Freeze and Harvest, reflected by the status of the Green and Yellow LEDs.
PAGE 10
  Smaller: By pressing the “Clean” button you can decrease the size of the ice cubes made. The green LED will blink as the size is lowered. When the lowest possible size is reached, the green LED will remain lit. Bigger: By pressing the “Mode” button you can increase the size of the ice cubes made. The red LED will blink as the size is increased. When the largest possible size is reached, the red LED will remain lit. After 10 seconds of inactivity, the unit will return to the previous mode.
PAGE 11
 Harvest: During the harvest cycle, the compressor is still operating, but the water pump has stopped. The ice cubes will slide off the evaporator into the storage bin, and the freeze cycle will restart when all the cubes have been harvested. When the ice bin is full, the ice maker will go into cold preservation mode and runs while maintaining a low temperature. NOTE: A complete cycle of the two stages takes between 15 and 40 minutes, depending on temperature and operating conditions.
PAGE 12
CARE AND MAINTENANCE Periodic cleaning and proper maintenance will ensure efficiency, top performance, and a long life for your ice maker. The maintenance intervals listed are based on normal conditions. NOTE: Never keep anything in the ice storage bin that is not ice: objects like wine and beer bottles are unsanitary and labels may slip off and plug up the drain. Cleaning Never use solvent based cleaning agents or abrasives on the interior of the unit.
PAGE 13
 Ice-making system Minerals removed from water during the freezing cycle will eventually form a hard, scaly deposit in the water system. Cleaning the system regularly helps remove the mineral scale build up. Hard water and a less effective filter may require the cleaning system to be cleaned more regularly, up to once every 6 months. o Ensure that there is no ice on the evaporator. If ice is being formed, wait for the cycle to complete before turning the ice maker OFF.
PAGE 14
PROBLEMS WITH YOUR ICE MAKER Most common problems can be solved easily, saving you the cost of a possible service call. Try the following suggestions to see if you can solve the problem before contacting Vinotemp at info@vinotemp.com. TROUBLESHOOTING GUIDE PROBLEM     Ensure ice maker is plugged in to electrical outlet. Check for a blown fuse and replace if necessary. Check if the power button is on. Remove any ice cubes and ensure ice-full probe is free of ice.
PAGE 15
TERMS AND CONDITIONS Vinotemp International (“Seller”) and the person or entity that acquires these goods from Seller (“Purchaser”) hereby fully agree to the following terms and conditions of the sale: Shipping fees are the responsibility of the Purchaser whether freight prepaid or freight collect.
PAGE 16
SERVICE & IMPORTANT NOTICE Upon receipt and inspection of unit, the supply cord must be replaced if it is damaged. Contact our customer service at 1-800-777-8466 or info@vinotemp.com. The manufacturer has a policy of continuous improvement on its products and reserves the right to change materials and specifications without notice. WARNING: Please do not place the unit within reach of children. For adult use only. Contact info@vinotemp.com with any questions or visit www.vinotemp.com 17621 S.