Use and Care Manual
9
1 7 6 2 1 S o u t h S u s a n a R o a d , R a n c h o D o m i n g u e z , C a l i f o r n i a 9 0 2 2 1
i n f o @ v i n o t e m p . c o m
SETTING A TEMPERATURE
You can set the temperature as required by pressing the UP or DOWN button. When you
press the two buttons for the first time, the LED readout will show the original temperature
set previously (the temperature preset at the factory is 38ºF/3°C).
The temperature will increase 1ºF/1°C if you press the UP button once, or the temperature
will decrease 1ºF/1°C if you press the DOWN button once.
To view the “set” temperature at any time, press the UP or DOWN button, the “set”
temperature will temporarily “flash” in the LED display for 5 seconds.
The internal storage temperature will appear in blue color in the temperature display window.
NOTE: When using the unit for the first time or after a long period of inactivity, there may be
a variance of a few degrees between the selected temperature and the temperature indicated
on the LED readout. This is normal due to the length of inactivity, and will correct itself after
the unit is run for a few hours. If the unit is unplugged, has lost power or is turned off, wait 3
to 5 minutes before restarting the unit. The unit will not restart before this time delay.
DYNAMIC COOLING/SILENT MODES
The Dynamic Cooling feature enables the temperature to be distributed evenly around the
interior so you can store all your goods under exactly the same excellent conditions.
In the Dynamic Cooling mode, the interior fan circulates the inside air evenly even if the set
temperature is reached. Dynamic Cooling is the factory preset mode. To change to Silent mode,
touch and hold the UP key for approximately five seconds. The appliance will beep three times
to confirm silent mode is on. To change back to Dynamic Cooling mode, touch and hold the
DOWN key for approximately five seconds. The appliance will beep five times to confirm
Dynamic Cooling mode is on.
SHELVES
To avoid damaging the door gasket, ensure that the door is fully opened when pulling the
shelves out of the rail compartment.
Any of the shelves can be removed to store larger items.
When removing the shelf out of the rail compartment,
make sure to remove all items first. Then move the
shelf to the position where the notch of the shelf is
exactly under the plastic post and lift the shelf. In order
to replace the shelf, repeat steps described above in
reverse.