Operating instructions

TECHNICAL DATA
Model no. VT-21TSP-2Z
Capacity 21 bottles*
Volume 65 liters
Voltage AC 110V
Frequency 60 Hz
Input Power 130W
Power Consumption (kWh
/
24h) 1.5
Temperature Range 45°- 64° F
Approx. Net Weight 40.3 lbs
Approx. Gross Weight 45.1 lbs
Approx. Unit Size (W x H x D) 11.81" x 33.27" x 23.43"
Approx. Packing Size (W x H x D) 14.17” x 34.65” x 25.79”
*Note: This wine cooler is designed to store up to 21 standard Bordeaux 750 ml bottles. Storing large and/or
oddly shaped bottles (including champagne and sparkling wine bottles) will decrease the capacity of your wine
cooler.
INSTALLATION
• Remove all packing material before using your wine cooler. Check to be sure all parts are
included and that the cooler is in good condition.
• IMPORTANT: Before connecting the unit to a power source, let it stand upright for approximately
24 hours. This will reduce the possibility of a malfunction in the cooling system from handling
during transportation.
• Clean the interior surface with lukewarm water and a soft cloth.
• This unit is designed for freestanding installation and indoor use only. Position the unit in a dry
and well-ventilated place. Avoid placing the wine cooler near any source of heat or moisture, or in
direct sunlight. Do NOT install the unit in a location with an ambient temperature that will fall
below 60°F.
• When positioning the cooler, 6 inches of space at the back and 10-12 inches of space on both
sides are suggested to ensure proper air circulation to cool the cooling system. There also must
be unlimited clearance at the top of the cooler to ensure proper air circulation.
• The unit is designed for freestanding installation only. It is not designed to be installed under a
counter, inside a cabinet, or in any location that does not allow the proper clearances on all sides,
as stated above.
• Place the wine cooler on a solid, level surface strong enough to support it when it is fully loaded.
To level the wine cooler, adjust the front leveling legs at the bottom of the wine cooler. To
ensure vibration and noise-free operation, do not install on carpet.
• For best performance it is recommended that you install the appliance in a location with an
ambient temperature between 60°-80°F. If the ambient temperature is above or below
recommended temperatures, the performance of the unit may be affected.
• Plug the wine cooler into an exclusive, properly installed-grounded wall outlet.
• Upon plugging the cooler into an electrical outlet, let the unit run for at least 30 minutes before
making any adjustments.
7
17621 South Susana Road, Rancho Dominguez, California 90221
[e-mail]