Operating instructions

8
WWW.VINOTEMP.COM
INSTALLING STAINLESS STEEL HANDLE
• Pull away the door gasket in the area where the handle is to be installed. The gasket is easily
removed by hand, no tools are necessary.
• Insert the two (2) Phillips head screws with the lock washers and flat washers through the
gasket side of the door frame until the screws pass through the door frame. Follow the
sequence shown in the figure.
• Align the handle with the screws installed in the above step. Tighten the screws using a Phillips
head screwdriver until the handles secure tightly against the door frame (DO NOT over tighten
as this will cause damage to the handle assembly). Replace the door gasket to its original
position.
OPERATING YOUR WINE COOLER
The wine cooler has an electric temperature control panel and two temperature zones. When first
turned on, the LED display will show the ambient temperature, followed by the internal cabinet
temperature.
The upper zone temperature can be set between 45° and 54°F. The lower zone can be set between
54 ° and 64° F. Pressing the “UP” button on the control panel will increase the temperature by 1°F
and pressing the “DOWN” button will lower it. Upon choosing your desired temperature, the display
will flash the selected temperature setting for 5 seconds before reflecting the current internal cabinet
temperature.
The “LIGHT” button turns the interior light On or Off. The C/F button alternates the temperature
reading between degrees Celsius and degrees Fahrenheit.