Specification

8
8
W W W . V I N O T E M P . C O M
INSTALLATION
BEFORE USING YOUR APPLIANCE
Remove all packing material before using your appliance.
IMPORTANT: Before connecting the unit to a power source, let it stand upright for approximately
24 hours. This will reduce the possibility of a malfunction in the cooling system from handling
during transportation.
Clean the interior surface with lukewarm water and a soft cloth.
INSTALLATION OF YOUR APPLIANCE
This unit is designed for built-in installation, but can also be used freestanding.
Position the unit in a dry and well-ventilated place. Avoid placing the cooler near any source of
heat or moisture, or in direct sunlight.
For freestanding installation, 5” of space at the back and both sides are suggested to ensure
proper air circulation to cool the compressor and condenser.
For built-in installation, leave a ¼” (6.35mm) space on each side and at the top, and 1-2” at the
back of the wine cooler to ensure proper air circulation to cool the compressor and condenser.
Also, be sure to not obstruct the front exhaust vent with anything as this may prevent the unit from
performing properly.
Place the appliance on a level surface strong enough to support it when it is fully loaded. To
level the wine cooler, adjust the front leveling legs at the bottom of the unit.
For best performance it is recommended that you install the appliance in a location with an
ambient temperature between 60°-90°F. If the ambient temperature is above or below
recommended temperatures, the performance of the unit may be affected.
It is recommended that you do not install the appliance near an oven, radiator or other heating
source. Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption.
Do not store or install the appliance outdoors, in a garage, basement, or in moist areas.
Plug the unit into an exclusive, properly installed-grounded wall outlet.
Do not lift unit by the door handle.
To level your appliance, adjust the front legs at the bottom of the appliance.
INSTALLING THE HANDLE
The stainless steel handle should be installed according to the following diagram: