A PROUD HERITAGE OF EXPERIENCE & QUALITY Wine Cooler VT-24PR125 O W N E R ’ S M A N U A L W W W . V I N O T E M P .
Your Wine Cellar This unit can be used for Storage and/or Service. The unit has a glass door and soft interior light that you can use to store your wine. Serving Wines Storing wines at the proper temperature is important. To preserve them as long as possible wine should be stored at approximately 55° Fahrenheit. However, the chart below suggests the optimal drinking temperature for the different styles of wine.
General Operating Instructions Remove all external and internal packaging from your appliance. Be sure that all parts have been included before discarding any packaging materials. You may want to keep the box and packing materials for use at a later date. Upon receipt and inspection of unit, the supply cord must be replaced if it is damaged. Contact our customer service at 1-800-777-8466 or info@vinotemp.com.
TABLE OF CONTENTS IMPORTANT SAFETY INSTRUCTIONS ......................................................... 5 ELECTRICAL CONNECTION ....................................................................... 6 PARTS AND SPECIFICATIONS ................................................................... 7 INSTALLATION ....................................................................................... 8 OPERATING YOUR APPLIANCE ................................................................
IMPORTANT SAFETY INSTRUCTIONS To reduce the risk of fire, electrical shock or injury when using your appliance, follow these basic precautions: • • • • • • • • • • • • • • • • • • • Do not operate this or any other appliance with a damaged cord. Do not operate if housing is removed or damaged. Exercise caution and use reasonable supervision when appliance is used near children. Never allow children to operate, play with or crawl inside the appliance. Keep packing materials away from children.
• • • • - Disconnect from the power supply, - Air the room in which the appliance is located for several minutes and - Contact the Service Department for advice. The more coolant there is in an appliance, the larger the room it should be installed in. In the event of a leakage, if the appliance is in a small room, there is the danger of combustible gases building up. For every ounce of coolant at least 325 cubic feet of room space is required.
PARTS AND SPECIFICATIONS Door Shelves(14) Digital Control Panel Handle Security Lock Ventilation Grille Adjustable Legs Model No. Voltage Frequency Cabinet VT-24PR125 AC 115V 60 Hz Ambient Temperature Range 44°- 90°F Control Temperature Range 41°- 68°F Refrigerant R600a/1.77oz Power Consumption 245 kWh/Year Input Power Volume 160W 11.94 Cu.Ft.
INSTALLATION • • • • • • • Remove all packing material before using your appliance. IMPORTANT: Before connecting the unit to a power source, let it stand upright for approximately 24 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation. Clean the interior surface with lukewarm water and a soft cloth. This unit is designed for freestanding or built in installation and indoor use only. Position the unit in a dry and well-ventilated place.
1. Remove the cover cap and then remove the glass door by unscrewing the four screws (1) and (4). Be careful to hold the glass door firmly after removing the screws and place it on a padded surface to avoid the risk of damage. 2. Unscrew and transfer the lock catch (3) to the opposite side. 3. Rotate the glass door 180° and refit the glass door to the opposite side. Then screw and tighten it after the door is leveled.
NOTE: 1. Weight of the overlay panel should not exceed 35 pounds (16 kilograms). 2. It is important to ensure that all drilled holes are drilled to the correct depth in order to avoid splits in the wood when hardware is installed. 3. Drill the handle installation holes in the overlay panel according to the handle you are planning to use. If reusing the handles came with the unit, drill two holes with holes distance 490mm (19-19/64”) and diameter 5mm (3/16”) in the overlay panel. Door Panel Installation 1.
OPERATING YOUR APPLIANCE CONTROLS ON/OFF Power To turn the appliance off, press and hold the key for 5 seconds until temperature display goes out. To turn the appliance on, press and hold the key for 1 second until temperature display lights up. NOTE: Pressing the POWER key once can switch off the audible alarm when the alarm is on. LIGHT Turn the interior light ON/OFF. UP Used to increase (warm) the set temperature by 1°C/1ºF. DOWN Used to decrease (cool) the set temperature by 1°C/1ºF.
temperature of the LOWER temperature zone. When you press either key at the first time, the display will show the last temperature set previously. • IMPORTANT: The temperature set for the LOWER temperature zone must always be just as high as or higher than that in the UPPER temperature zone. For optimal performance, the set temperature of the two zones should differ by at least 4°C (7F°).
To initiate Sabbath mode, press the POWER and LIGHT keys at the same time for at least 5 seconds. The indicator light will flash four times and confirm the Sabbath mode is ON. Sabbath mode can be canceled by repeating the above process. The Sabbath Mode will automatically turn off after 48 hours. TEMPERATURE MEMORY FUNCTION • In the event of a power interruption (power surge, breaker switch, etc.
SHELVES To prevent damaging the door gasket, make sure to have the door all the way open when pulling the shelves out of the rail compartment. • • For easy access to the stored bottles, you can pull the shelf fully out of the rail compartment. To remove a shelf, extend the shelf out of the rail compartment until it stops and remove all bottles from the shelf. Then lift the shelf front straight up and then grasp the slides (2) and push the shelf (1) straight inward to release the shelf from the slides.
POWER FAILURE Most power failures are corrected within a few hours and should not affect the temperature of your appliance. If the power is off for an extended period of time, proper steps should be taken to protect your contents. INACTIVITY If the unit will not be used for a period of less than three weeks, leave the unit operating. If the period of inactivity is several months, remove all items and turn the unit off. Clean and dry the interior thoroughly.
PROBLEMS WITH YOUR APPLIANCE Most common problems can be solved easily, saving you the cost of a possible service call. Try the following suggestions to see if you can solve the problem before contacting Vinotemp at info@vinotemp.com. TROUBLESHOOTING PROBLEM Appliance does not operate. Appliance is not cold enough. Appliance turns itself on and off frequently. The light does not work. Vibrations The appliance seems to make too much noise.
• There are popping and cracking noises. • The appliance is not properly leveled. The door will not close properly. Display “E1”, “E2” or “E7”. The alarm sounds and the temperature display flashes. The icon “--” is lit and flashing in the temperature display. • The appliance is not properly level. • The door was reversed and not properly installed. • The gasket is dirty. • The shelves are out of position. • “E1”or “E2” indicates the air temperature sensor has failed.
TERMS OF SALE AND WARRANTY Vinotemp International Corp. (“Seller”) and the person or entity that acquires these goods from Seller (“Purchaser”) hereby fully agree to the following terms and conditions of the sale: Shipping fees are the responsibility of the Purchaser whether freight prepaid or freight collect. Seller assumes responsibility for the goods sold to the Purchaser until the goods have reached Purchaser’s delivery address (FOB Destination) and the delivery receipt is signed clear.
the goods. Built to Order and Custom products are nonreturnable, nonrefundable. Purchaser must notify Seller of nonconforming goods within 48 hours of receipt, after which time all goods are deemed accepted by the Purchaser. If an order has been placed and production has not started, cancellation of your order will be a 15% charge.
This Limited Warranty does not cover damage due to such things as accident, misuse, abuse, mishandling, neglect, acts of God, fires, earthquakes, floods, high winds, government, war, riot or labor trouble, strikes, lockouts, delay of carrier, unauthorized repair, or any other cause beyond the control of the Seller, whether similar or dissimilar to the foregoing. Seller is not responsible for any damages caused to Purchaser's property resulting from the goods.
732 South Racetrack Road, Henderson, Nevada 89015 info@vinotemp.
SERVICE & IMPORTANT NOTICE Upon receipt and inspection of unit, the supply cord must be replaced if it is damaged. Contact our customer service at 1-800-777-8466 or info@vinotemp.com. The manufacturer has a policy of continuous improvement on its products and reserves the right to change materials and specifications without notice. WARNING: Please do not place the unit within reach of children. For adult use only. Contact info@vinotemp.com with any questions or visit www.vinotemp.
