User Guide

11
17621 South Susana Road, Rancho Dominguez, California 90221
[e-mail]
NOTE:
1. Weight of the overlay panel should not exceed 20 pounds (9.1 kilograms).
2. It is important to ensure that all drilled holes are drilled to the correct depth in
order to avoid splits in the wood when hardware is installed.
3. Drill the handle installation holes in the overlay panel according to the handle you
are planning to use. If reusing the handles came with the unit, drill two holes
with holes distance 707mm (27-53/64”) and diameter 5mm (3/16”) in the
overlay panel.
Door Panel Installation
1. Remove the bottom hinge assembly (2) by unscrewing the four lock screws (1). Be
careful to hold the door (4) firmly after removing the screws. (Fig. 1)
2. Gently pull down to remove the door from the right top hinge and place it on a padded
surface to avoid the risk of damage. (Fig. 2)
3. Remove door gasket (9) completely from door (4). Start in a corner and pull outward.
This may take some force. Set gasket down on a flat surface for later installation.
4. Remove the door adapters (6) and hinge sleeves (7) by unscrewing the screws (8).
5. Attach the wood overlay panel (3) to the door face by using 8 wood screws #10x1.5
(ST4x40) Type AB Philips (5).
6. Repeat steps described above in reverse to replace the door adapters (6), hinge sleeves
(7) and gasket (9).
7. Relocate the finished door to the designated position. Then screw the bottom hinge
assembly and tighten it after the door is leveled.