Manual

1
6
16
W W W . V I N O T E M P . C O M
PROBLEMS WITH YOUR APPLIANCE
Most common problems can be solved easily, saving you the cost of a possible service
call. Try the following suggestions to see if you can solve the problem before
contacting Vinotemp at [e-mail].
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
REMEDY
Appliance
does not
operate.
Appliance is not connected to a
power supply.
The appliance is turned off.
Tripped circuit breaker or a blown
fuse.
Connect the appliance.
Switch on the appliance.
Switch on circuit breaker or replace
fuse.
Appliance is
not cold
enough.
The temperature is not set correctly.
The ambient temperature could
require a lower temperature setting.
The door was opened too often.
The door was not closed completely.
Door does not create an airtight seal.
The condenser is too dirty.
The ventilation opening is blocked or
too dusty.
Check the set temperature.
Set a lower temperature.
Do not open the door more often
than necessary.
Close door properly.
Check the door seal and clean or
replace.
Clean the condenser when
necessary.
Clear the obstructions and clean
the dust.
Appliance
turns itself
on and off
frequently.
The room temperature is higher than
average.
A large amount of food has been
added to the unit.
The door is open too often.
The door is not closed completely.
The door gasket does not seal
properly.
Put the appliance in a cooler place.
Leave the appliance to work for a
while until the set temperature has
been reached.
Do not open the door more often
than necessary.
Close door properly.
Check the door seal and clean or
replace.
The light
does not
work.
Appliance is not connected to a
power supply.
Tripped circuit breaker or a blown
fuse.
The light was switched off on the
control panel.
Connect the appliance.
Switch on circuit breaker or replace
fuse.
Switch on the light.
Vibrations
The appliance is not properly level.
Level the appliance with the
adjustable feet.
The
appliance
seems to
make too
much noise.
There is a rattling noise.
There are gurgling sounds.
There are popping and cracking
noises.
This noise may be caused by the
internal flow of the refrigerant.
This is normal.
As each cycle ends, these sounds
may be caused by the flow of
refrigerant in the appliance.
These sounds are usually caused
by internal temperature