Installation Manual

There are three pre-drilled mounting holes in each strip, six total per rack (WS1x have 2 holes per strip, 4 total).
Appropriate fasteners for your wall surface must be utilized in every mounting hole for proper installation. Fasteners for
drywall or wood wall surfaces are included with your rack. We recommend the following fasteners for these surfaces:
Fasteners:
• Attaching to drywall, use all of the included Spiral Drywall Anchors and corresponding number of Screws along
with 2 Toggle Bolts
• Wood wall surfaces can use the included Screws
• Concrete, Brick or Stucco: 3/16” x 1 ¼” masonry screw or #8 x 1 ¼” screw with appropriate size expanding
concrete anchor - not included
• VintageView® Floor to Ceiling Frame (FCF-HD): Each FCF-HD comes with self-drilling screws to attach WS series
racks to the frames
Before you begin, choose the direction the bottle necks should point
If the bottle necks are to point to the right, the base strip
must be installed to the left of the neck strip.
WS1x, WS2x, WS3x and WS4x Installaon Instrucons
Wine Master Cellars, LLLP • 10645 E 47th Ave, Denver, CO 80239 • phone: [phone] • fax: [phone] • VintageView.com
Required tools: Phillips Head Screw Driver
Level
Pencil
Tape Measure
Drill and 13/32 inch (10.3mm) drill bit
Included Parts: 1 Base Strip 4 Spiral Drywall Anchors†
1 Neck Strip 6 Screws†
6 Mounting Hole Caps† 2 Toggle Bolts
2 Plastic Couplers
† WS1x will come with 2 fewer
2. Mark the hole locations for the strip - Hold either the neck
or base strip of the rack in place against the wall, centered on the
rstmarktheappropriatedistanceabovetheoor.Ensurethat
the rack is vertical using a level and mark the hole locations with
a pencil (Figure B) then set the strip aside.
>23/4"
If the bottle necks are to point to the left, the base strip
must be installed to the right of the neck strip.
Figure B
1. Lay out the wall - Starting at least 2-3/4 inches (70mm) from
adjacent walls or other obstructions, mark the centerline of the
rststrip.From there,measure 7-1/2 inches(190.5mm) to the
centerline between the neck and base strip and mark the location.
Optional: If installing multiple columns, mark the centerline for
the next strip 5-1/2 inches (139.7mm) from the second mark
andmark again 7-1/2inches(190.5mm) fromthat markfor the
distance between the neck and the base strips of the second
column. To lay out additional columns, mark the wall, alternating
between5-1/2and7-1/2inches(139.7mmand190.5mm).
23/4"
71/2"
51/2"
71/2"
Figure A
Note: If installing rack-
ingfor375mLbottles,
please adjust the
centerline dimension
toapproximately5-1/2
inches(139.7mm)
between the base and
neck strips. Modify this
dimension as appropri-
ate for the actual bottle
size you have to ensure
that less than 1/3 of
the base of the bottle
overhangs the base
strip and the bottle will
not fall between the
rods when the shoul-
der of the bottle rests
against the neck rod.