Installation Guide

Each WS3x or WS4x contains:
WS3x and WS4x Wall Mount
Wine Rack Instructions
Wine Master Cellars •10645 E 47th Ave, Denver, CO 80239 • phone: [phone] • fax: [phone]
Please feel free to contact us regarding the assembly of this product.
Wine storage system
Tools Needed:
Before starting, open all Packaging for the WS3x or WS4x and take inventory to make sure you have everything.
• 1 Neck Strip
• 2 Plastic Couplers
• 1 Spirit Level
• 1 Marking Pen or Pencil
• 1 Tape Measure
• 1 Screwdriver
• Drill and Drill Bits (Necessary in Some Cases)
There are three pre-drilled mounting holes in each strip, six total per rack. Appropriate fasteners must be utilized in every
mounting hole for proper installation. Fasteners are not included with your WS3x or WS4x. However, we recommend the
following fasteners for these surfaces:
Fasteners:
• Wood Surface: #8 x 1-1/4” wood screw
• Drywall/Wallboard Surface: #8 x 1-1/4” screw with spiral inserts for the bottom two holes in each strip (4 total) and
an expanding hollow wall anchor such as a toggle bolt for the top hole in each strip (2 total)
• Concrete, Brick or Stucco: 3/16” x 1 ¾” masonry screw or #8 x 1 ¼” screw with appropriate size expanding anchor
NOTE: If you are attaching the WS3x or WS4x to a VintageView® Floor to Ceiling Frame (FCF) you will attach the
units to the FCF using the self-drilling screws included in the FCF packaging.
WS3x and WS4x Installation Instructions
1 - Determine which direction the bottle necks should point.
• 1 Base Strip
• 6 Rubber Mounting Hole Caps
1.1. If the bottle necks are to point to the right, the base
strip must be installed to the left of the neck strip.
1.2. If the bottle necks are to point to the left, the base
strip must be installed to the right of the neck strip.
2.1. The centerline of the rst strip (either base or neck de-
pending on bottle neck direction) must be at least 2-3/4” from
adjacent walls or obstructions. This allows for the bottle to
overhang the rack.
2.2. From centerline of the rst strip, measure 7-1/2” to the
centerline of the next strip.
2.3. (For multiple columns) locate the centerline of the next
strip 5-1/2” away from the prior strip.
2.4. (For multiple columns) continue marking the centerlines,
alternating between 7-1/2” and 5-1/2” increments.
2 - Lay out the wall.
M
O
U
N
T
I
N
G
H
A
R
D
W
A
R
E
N
O
T
P
R
O
V
I
D
E
D
2 3/4"
7
1/
2"
5
1/
2"
7
1/
2"