______________________________________________ MANUAL - WINE CABINETS V50DG “2E” ______________________________________________
Instruction Manual for V50DG “2e” Safety Instructions Attention Do Not Use An Extension Cord Use an exclusive wall outlet. Do not connect your wine cooler to extension cords or together with any other appliance in the same wall outlet. Do not splice the cord. Important Warning An empty refrigerator is a very dangerous attraction to children. Remove either the gasket, latches, lids or doors from unused appliances, or take some other action that will guarantee it harmless. Danger: Risk of child entrapment.
Attention: • Store wine in sealed bottles. • Do not overload the cabinet. • Do not open the door unless necessary • Do not cover shelves with aluminium foil or any other shelf material which may prevent air circulation. • Should the wine cooler be stored without use for long periods it is suggested, after a careful cleaning, to leave the door ajar to allow air to circulate inside the cabinet in order to avoid possible formations of condensation, mold or odors.
Setting The Temperature Controls: Each cooling compartment of the wine cooler (upper and lower) is independently controlled. To set the temperature: 1. Connect the power cord to a properly grounded outlet. In the event of a power interruption, all previous temperature settings are automatically erased and each compartment will default to a preset temperature setting of 7o C (45o F) Left compartment 12o C (54o F) Right compartment 2.
Defrosting / Condensation Your wine cooler is designed with an “Auto-Cycle” defrost system. During the “Off Cycle” the refrigerated surfaces of the wine cooler (interior rear wall) defrost automatically. The defrost water is channeled into a condensate drain pan which is located at the back of the wine cooler next to the compressor from where it evaporates. Care and Maintenance Upon receiving your wine cooler, leave the door open for 24 hours.