User Manual VWS020SBA-X VBS020SBA-X vintec.
Table of Contents WARNING ..................................................... 3 INSTALLATION ..................................................... 4 STORAGE ..................................................... 6 OPERATION & WINE SERVING ..................................................... 7 DEFROSTING & DOOR REVERSAL ..................................................... 8 TROUBLESHOOTING ..................................................... 9 DATA ...........................................
WARNING The information in this document is subject to modification without any prior notice. Some models are available in dedicated countries only. VINTEC offers no guarantee for our Wine Cellar and Beverage Centre if it is being used for any purpose other than that for which it was specifically designed. VINTEC cannot be held responsible for any error in this manual.
Allow 24 hours before switching on the Wine Cellar and Beverage Centre. During this time we recommend that you leave the door open to clear any residual odours. BEFORE LOADING & PLUGGING IN THE Wine Cellar and Beverage Centre. Important: All models without front venting (air opening) are strictly for free standing only. (See technical chart). Recommendations: The location you have selected for your Wine Cellar and Beverage Centre should: is accessible. Release the power cord.
INSTALLATION UNDER-BENCH INSTALLATION INSTRUCTIONS DIMENSIONS: VWS020SBA-X/VBS020SBA-X Height 820mm – 870mm (50mm adjustable feet) Width 295-300 mm Depth 561mm + 30mm stopper (Total of 591mm) For VWS020SBA-X/VBS020SBA-X a minimum cut out width of 320mm is required to facilitate installation, removal and servicing. INSTALLATION DRAWINGS FOR fornt venting under bench Wine Cellars and Beverage Centres: Front View (VWS020SBA-X / VBS020SBA-X) Suitable pointe for ventilation grid.
STORAGE TURNING ON YOUR Wine Cellar and Beverage Centre Plug in and switch on the cellar by pressing on the power button for a few seconds. When you use the Wine Cellar and Beverage Centre for the first time (or restart the Wine Cellar and Beverage Centre after having it shut off for a long time), there will be a few degrees variance between the temperature. You have selected and the one indicated on the LED readout. This is normal and it is due to the length of the activation time.
OPERATION & WINE SERVING TEMPERATURE SETTINGS Important: The LCD displays by default the actual internal air temperature. The temperature settings are pre-set at the factory as follows. In the event of a power interruption, all previous temperature settings are automatically erased and it will revert to the preset temperature settings. Factory preset chart Model Setting Temperature VWS020SBA-X 12℃ 12℃(+/-2.5℃) VBS020SBA-X 6℃ 6℃(+/-2.
DEFROSTING & DOOR REVERSAL Temperature Chart above). This being said and as it is for natural cellars used by wine producers for long periods of storage, it is not the exact temperature that is important, but its consistency. In other words, as long as the temperature of your Wine Cellar and Beverage Centre is constant (between 12℃ to 14℃) your wines will be stored in perfect conditions. Not all wines will improve over the years.
TROUBLESHOOTING 1. Open the door to a 90 degrees angle, take out the 2 screws from lower door axis, remove the door , Remove the axis plate from the door. Unscrew the screw located underneath the doorframe and the limit device , and relocate it at left end side of the door frame. 2. Take out the 3 hinge screws from the lower hinge (right) and remove it. 3. Take out the 3 hinge screws from the top hinge (right) and remove it. 4.
DATA Technical Data: Models Capacity VWS020SBA-X 750ml bordeaux Bottles 375ml Beer Bottles VBS020SBA-X 19 - - 53 Gas charge(g) 25g 25g Net capacity 56L 56L Preset Temperature (°C) 12°C 6°C Adjustable tmep in degrees Heater (1) Freestanding or Built-in Number of shelves: (1) Ambient temperature range (°C) Dimensions (mm) (WxDxH) Packaged Dimensions (mm) (WxDxH) Net weight Gross weight 6 - 18 °C 2-10°C - - Built-in Built-in 6(5+base) 3 5-35°C 5-35°C 295x561x820 295x561x820 340x6
Warranty FOR SALES IN AUSTRALIA AND NEW ZEALAND APPLIANCE: ALL VINTEC/TRANSTHERM This document sets out the terms and conditions of the product warranties for Vintec/Transtherm Appliances. It is an important document. Please keep it with your proof of purchase documents in a safe place for future reference should there be a manufacturing defect in your Appliance. This warranty is in addition to other rights you may have under the Australian Consumer Law.
Service and support In the rare event that your Vintec cabinet does not perform to your satisfaction, contact our dedicated support team: 1800 771 776 concierge@vintecclub.com Vintec. We are part of the Electrolux Family. To add a touch of professional inspiration to your home, visit electrolux.com.au Stay in touch and share your user experience by following us: @vintecclub © 2019 Electrolux Home Products Pty Ltd. ABN 51 004 762 341 VMAN_XXXXXX_Jun19 vintec.
