User Manual MODELS: VWS035SCA-X VWS035SBA-X VWS035SSA-X VWS035TBA-X VWS048SCA-X vintec.
Table of Contents WARNING ..................................................... 3 INSTALLATION ..................................................... 4 INSTALLATION & STORAGE ..................................................... 5 /6 OPERATION ..................................................... 7 WINE SERVING & DEFROSTING ..................................................... 8 DOOR REVERSAL ..................................................... 9 DATA ...........................................
WARNING The information in this document is subject to modifica tion without any prior notice. Some models are available in dedicated countries only. VINTEC offers no guarantee for our Wine Cellar if it is being used for any purpose other than that for which it was specifically designed. VINTEC cannot be held responsible for any error in this manual. VINTEC is not responsible or liable for any spoilage or damage to wines or any other contents incidental or consequential to possible defects of the Wine Cellar.
INSTALLATION should: - be unencumbered and well ventilated; - be well away from any heat source and direct sunlight; - not be too damp (laundry, pantry, bathroom etc.); - have a flat floor; - have a standard and reliable electricity supply (standard socket to country standards, linked to the ground). It is NOT recommended to use a multi-socket or extension lead; - have a surge protector fitted to the electrical outlet; - away from the microwave oven.
INSTALLATION & STORAGE #1. Vintec “Built in” Wine Cellar are front venting but are not designed to be fully integrated behind a joinery door. #2. Vintec “Built in” Wine Cellar require 10mm clearance on both sides and top, 30mm clearance at the rear (Back spacer is provided), to facilitate installation, removal, servicing and ventilation. #3. Vintec “Built in” Wine Cellar draw air from the rear and expels it through the metal grid under the door at the front.
OPERATION TURNING ON YOUR Wine Cellar Plug in and switch on the cellar by pressing on the power button for a few seconds. When you use the Wine Cellar for the first time (or restart the Wine Cellar after having it shut off for a long time), there will be a few degrees variance between the temperature you have selected and the one indicated on the LED readout. This is normal and it is due to the length of the activation time. Once the Wine Cellar is running for a few hours everything will stabilise.
OPERATION It is important to understand that there is a difference between the air temperature inside the Wine Cellar and the actual temperature of the wine: You will need to wait approximately 12 hours before noticing the effects of temperature adjustment due to the critical mass within a full Wine Cellar . Once the temperature is set, it is strongly advised not to toy with it or adjust frequently. The thermostat will maintain the temperature inside the Wine Cellar within a +/- 2.5 ℃ range.
WINE SERVING & DEFROSTING&DOOR REVERSAL Temperature Chart above). This being said and as it is for natural cellars used by wine producers for long periods of storage, it is not the exact temperature that is important, but its consistency. In other words, as long as the temperature of your Wine Cellar and Bis constant (between 12℃ to 14℃) your wines will be stored in perfect conditions. Not all wines will improve over the years.
DOOR REVERSAL #1. Open the door to a 90 degree angle, take out the 2 screws from door axis , remove the door , Remove the Door axis . #2. Unscrew the screw located underneath the door frame and the limit device, and relocate it at left the end side of the door frame. #3. Take out the 3 hinge screws from the top hinge (right)and remove it. #4. Remove decorative nail from left top of cabinet and install spare top hinge (Left) at left top of cabinet with 3 screws. #5. Overturned the lower hinge.
TROUBLESHOOTING & DATA warranty being considered as null and void. POWER FAILURES not affect Wine Cellar temperatures. To avoid sudden change of temperature while the power is off, you should avoid opening the door. For longer period sof power failure, do take steps to protect your wine. cause a detrimental effect on your wines.
TROUBLESHOOTING GUIDE Common problems may easily be solved, saving you the cost of a possible service call. PROBLEM Wine Cellar does not operate. POSSIBLE CAUSE Not plugged in. The appliance is turned off. The circuit breaker tripped or the fuse isbroken. Wine Cellar is not cold enough. The door is not closed completely. The door gasket does not seal properly. The room temperature is higher than normal. A large amount of contents has been added to the Wine Cellar . Turns on and off frequently.
Service and support In the rare event that your Vintec cabinet does not perform to your satisfaction, contact our dedicated support team: 1800 771 776 concierge@vintecclub.com Vintec. We are part of the Electrolux Family. To add a touch of professional inspiration to your home, visit electrolux.com.au Stay in touch and share your user experience by following us: @vintecclub © 2019 Electrolux Home Products Pty Ltd. ABN 51 004 762 341 VMAN_XXXXXX_Jun19 vintec.
