User Manual

INSTALLATION
Improper use of the grounding plug can result in the risk
of electric shock. Consult a qualified electrician or service
person if the grounding instrucons are not completely
understood. If the supply cord is damaged, it must be
replace by a qualified person in order to avoid electrical
hazard.
INSTALLING YOUR Wine Cellar
Unpack and remove all of the protecon and adhesive
strips from the packaging around and inside the Wine
Cellar. The Wine Cellar must be posioned such that
the plug is accessible. Release the power cord.
Move your Wine Cellar to its final locaon. The Wine
Cellar should be installed in a suitable place where the
compressor will not be subject to physical contact.
Leveling your Wine Cellar : Wine Cellar must be leveled
BEFORE loading your wines.
Your Vintec Wine Cellar is equipped with 4 adjustable
feet to facilitate easy leveling.
VINTEC recommends that you ghten the back feet to
the maximum and adjust the front feet to level of the
Wine Cellar .
socket to country standards, linked to the ground). It is
NOT recommended to use a mul-socket or extension
lead;
- have a surge protector fied to the electrical outlet;
- away from the microwave oven. Certain microwave
ovens do not have wave interference shield. When
placed within 1 meter vicinity of the wine cabinet, they
may affect the operaon of the wine cabinet.
Notes:
VWS048SCA-X model is built-in type as per the
drawings thereaer.
The Wine Cellar should be placed where the ambient
temperature is between 5℃ to 35℃.If the ambient
temperature is above or below this range,If the
ambient temperature is above or below this range,
the performance of the unit may be affected. Placing
your unit in extreme cold or hot condions may cause
interior temperatures to fluctuate. The ideal range of
temperature may not be reached. (See Climate Class
at the end of this manual).
Grounding instrucons
The Wine Cellar must be grounded in case of an
electrical short circuit. Grounding reduces the risk of
electrical shock. The Wine Cellar s equipped with a
power cord having a grounding wire and plug. The Wine
Cellar plug must be plugged into a properly affixed and
grounded electrical outlet.
Note: In locaons where there is frequent lightning, it is
advisable to use surge protectors.
IMPORTANT - THIS SPACER MUST BE ATTACHED TO
THE UNIT BEFORE. THE INSTALLATION, FOR
VENTILATION PURPOSE. FAILURE TO DO SO VOIDS
THE WARRANTY
INSTALLATION INSTRUCTIONS FOR BUILT IN Wine
Cellar : (UNDERBENCH OR IN COLUMN) FRONT
VENTING Wine Cellar ONLY.
UNDER-BENCH INSTALLATION INSTRUCTIONS
VWS035SCA-X/VWS035SBA-X/VWS035SSA-X
VWS035TBA-X models are free standing only. Any
built in voids the warranty
DIMENSIONS:
VWS048SCA-X
Height 875mm
Width 605mm
Depth 603mm + 30mm stopper (Total of 633mm)
This Vintec Wine Cellar is not designed to be fully
integrated behind a joinery door.
Please note that:
For VWS048SCA-X
a minimum cut out width of 625mm is required to
facilitate installaon, removal and servicing.
Fixing the Back spacer:
Compressor run appliances require good venlaon
for effecve and longer usage. Your Vintec Wine
Cellar is supplied with a back spacer.
Affix the back spacer at the back of the cellar for air
circulaon and heat evacuaon.
- not be too damp (laundry, pantry, bathroom etc.);
- have a flat floor;
- have a standard and reliable electricity supply (standard
should:
- be unencumbered and well venlated;
- be well away from any heat source and direct sunlight;
4
User Manual