User Manual

INSTALLATION & STORAGE
Front View (VWS048SCA-X )
Failing to comply with the above specificaons could
result in WARRANTY void.
INSTALLATION DRAWINGS FOR BUILT IN Wine Cellar :
(UNDERBENCH OR IN COLUMN)FRONT VENTING
Wine Cellar ONLY.
#1. Vintec “Built in” Wine Cellar are front venng but
are not designed to be fully integrated behind a
joinery door.
#2. Vintec “Built in” Wine Cellar require 10mm clearance
on both sides and top, 30mm clearance at the rear
(Back spacer is provided), to facilitate installaon,
removal, servicing and venlaon.
#3. Vintec “Built in” Wine Cellar draw air from the rear
and expels it through the metal grid under the door at
the front. If a kick board is to be placed in front of the
Wine Cellar grid another one must be fied into the
kick board with a minimum air flow allowance of
150cm².
#4. Vintec “Built in” Wine Cellar have a power switch l
ocated on the control panel so power point locaon
is not crical.
#5. The Wine Cellar requires a standard 240 volt/10 amp
power point. (Or according to different countries
specificaons).
#6. The power cord is 1.9m in length and is fixed on the
right side at the back when looking from front of
cabinet.
#7. As with most appliances of today, the Wine Cellar has
sensive electronic components which are suscepble
to damage through lightning and electricity supply
faults. It is therefore advised to use a power surge
protector to avoid problems of this nature.
#8. Air vent within the joinery must be provided for
Vintec built in Wine Cellar (front venng)
In Hot climate zone, an air vent or grid, with a minimum
venlaon size of 200mm x 40mm MUST be cut out at
the rear top of the back paroning or at the top of
either side of the paroning, allowing cool fresh air
full access to flow into the 30mm gap located at the
rear of the cabinet.
This air vent or grid must not be opened on the same
side as other appliances such as ovens or an area that
is sealed and without access to fresh cool air.
Cross secon
Dimensional drawings:
VWS048SCA-X
10mm
625mm
5
User Manual