User Manual

OPERATION
Model
Seng
12℃
VWS035SCA-X
VWS035SBA-X
VWS035SSA-X
VWS035TBA-X
VWS048SCA-X
Temperature
12℃(+/-2.5℃)
TURNING ON YOUR Wine Cellar Plug in and switch
on the cellar by pressing on the power buon for a
few seconds.
When you use the Wine Cellar for the first me (or
restart the Wine Cellar aer having it shut off for a
long me), there will be a few degrees variance
between the temperature you have selected and the
one indicated on the LED readout. This is normal and
it is due to the length of the acvaon me. Once the
Wine Cellar is running for a few hours everything will
stabilise.
OPERATING NOISES
To reach the desired temperature sengs, VINTEC
Wine Cellar , like all Wine Cellar and may produce the
following types of noises. These noises are normal and
may occur as follows:
- Gurgling sound - caused by the refrigerant flowing
through the appliance’s coils.
- Cracking/popping sounds - resulng from the
contracon and expansion of the refrigerant gas to
produce cold.
- Fan operang sound - to circulate the air within the
Wine Cellar .
An individual’s percepon of noise is directly linked to
the environment in which the Wine Cellar is located, as
well the specific type of models.
VINTEC Wine Cellar are in line with internaonal
standards for such appliances.
VINTEC will always do its utmost to sasfy its
customers but will not retake possession of the goods
due to complaints based on normal operang noise
occurrences.
LOADING YOUR Wine Cellar
You may load your wine boles in single or double rows
while taking note of the following: if you do not have
enough boles to fill your Wine Cellar , it is beer to
distribute the load throughout the Wine Cellar so as to
avoid all on top or all below type loads.
- Do remove or relocate adjustable wooden shelves to
accommodate larger type of boles or increase the
capacity of the cellar by stacking the boles up when
necessary (See removing shelves).
- Keep smalls gap between the walls and the boles to
allow air circulaon. Like an underground cellar air
circulaon is important to prevent mould and for a
beer homogeneous temperature within the cellar.
- Do not over load your Wine Cellar to facilitate air
circulaon.
- Do not stack more than 1.5 rows of standard 0.75L
boles per shelves to facilitate air circulaon.
- Avoid obstrucng the internal fans (located inside
on the back panel of the Wine Cellar).
- Do not slide the shelves outwards beyond the fixed
posion to prevent the boles from falling.
- Do not pull out more than one loaded shelf at a time
asthis may cause the Wine Cellar to tilt forward.
- Do not cover the wooden shelves with alloy foil or
other materials, as it will obstruct air circulaon.
- Do not move your Wine Cellar while it is loaded
with wines. This might distort the body of the Wine
Cellar and cause back injury.
TYPES OF REGULATION
Please note that depending on the loading and
sengs chosen it takes about 24 hours for the Wine
Cellar to see the temperature stabilizing. During this
me the LED seems to move erracally in parcular
for dual zone models. It is normal and this process
occurs whenever the seng is modified and/or
whenever a large amount of boles are added to the
cellar.
Designed to store and mature all wines: red, white
and sparkling. These Wine Cellar reproduce the
ideal condions for wine storage, at a constant
recommended temperature of 12℃. They can also
be set to provide ideal serving temperature for full
enjoyment of the wine’s qualies. Unless stated by
the wine maker on the bole, VINTEC recommends
7℃ for your champagne, 12℃ for whites and 18℃
for reds (Refer to Wine Service Temperature
recommendaon chart).
Designed to store wines at the correct temperature
for best enjoyment. The upper chamber can hold 12,
14 or 16 boles, depending on the models, at a
temperature of 5℃ to 10℃ dedicated mainly to
white, sparkling wines and champagnes. The lower
chamber accommodates 20, 30 or 34 boles,
depending on the models, mainly for red wines,
which could be stored either at room emperature
(18℃-20℃) for consumpon or at 12℃ for a longer
me of storage.
TEMPERATURE SETTINGS
Important: The LCD displays by default the actual
internal air temperature.
The temperature sengs are pre-set at the factory
as follows. In the event of a power interrupon, all
previous temperature sengs are automacally
erased and it will revert to the preset temperature
sengs.
Factory preset chart
Important: If the unit is unplugged, turned off, or
power is lost due to an electricity power outage
wait 3 to 5 minutes before restarting the unit.
The Wine Cellar will not start if you attempt
to restart before this time delay.
6
User Manual