User Manual

Improper use of the grounding plug can result in the risk
of electric shock. Consult a qualified electrician or service
person if the grounding instrucons are not completely
understood. If the supply cord is damaged, it must be
replace by a qualified person in order to avoid electrical
hazard.
INSTALLING YOUR Wine Cellar
Unpack and remove all of the protecon and adhesive
strips from the packaging around and inside the Wine
Cellar. The Wine Cellar must be posioned such that
the plug is accessible. Release the power cord.
Move your Wine Cellar to its final locaon. The Wine
Cellar should be installed in a suitable place where the
compressor will not be subject to physical contact.
Leveling your Wine Cellar : Wine Cellar must be leveled
BEFORE loading your wines.
Your Vintec Wine Cellar is equipped with 4 adjustable
feet to facilitate easy leveling.
VINTEC recommends that you ghten the back feet to
the maximum and adjust the front feet to level of the
Wine Cellar .
VWS035SSA-X/VWS035TBA-X
VWS048SCA-X
OPERATION ANOMALIES
Ensure that there is power to the electrical supply
plug by connecng another electrical appliance to
it. Check fuse, if any. Make sure that the door is
closed properly.
If your Wine Cellar appears to be malfunconing,
unplug it and contact your VINTEC’s aersales
service.
Any intervenon on the cold circuit should be
performed by a refrigeraon technician who
should carry out an inspecon of the circuit sealing
system. Similarly, any intervenon on the electrical
circuit should be performed by a qualified electrician.
DOOR REVERSAL
#1. Open the door to a 90 degree angle, take
out the 2 screws from door axis , remove
the door , Remove the Door axis .
#2. Unscrew the screw located underneath
the door frame and the limit device, and
relocate it at le the end side of the door
frame.
#3. Take out the 3 hinge screws from the top
hinge (right)and remove it.
#4. Remove decorave nail from le top of
cabinet and install spare top hinge (Le)
at le top of cabinet with 3 screws.
#5. Overturned the lower hinge. Install the
lower hinge at le lower of the cabinet
with 3 screws(5).
- The door axis revolves 180 degree, Put it
into the door axis hole of the door.
#6.Install and aligne the door. Screw down
the 2 screws(1).
#7. Insert the plasc caps to cover the holes.
#1. Unscrew and remove the decorave cover.
While holding the door firmly, loosen and
remove the top hinge, li up and remove
the door .
#2. Unscrew the lower hinge .
#3.-Remove the long cabinet leg on the le
side, and shi it to the right end side.
- Install the lower hinge and e it with the
bolts.
- Install the door on the axis of lower hinge
the same way it was removed, screw back
the top hinge on the right.
#4. Fix back the decorave cover and rubber cover.
#1. Unscrew and remove the decorave cover.
While holding the door firmly, loosen and
remove the top hinge, li up and remove
the door.
#2. Unscrew the lower hinge .
#3.- Install the lower hinge and e it with the
bolts.
- Install the door on the axis of lower hinge
#4.- the same way it was removed, screw back
the top hinge on the right
- Fix back the decorave cover and rubber
cover.
9
User Manual