Instruction Manual

Fusion FH-100 and FHR-100 pan and tilt heads

Accessories

The head is supplied with standard accessories (Fig. 4), including four fixing bolts and washers

used when mounting the head onto a tripod or pedestal mounting plate, a Vinten spanner and

two telescopic pan bars for use when the head is operated manually.

Optional accessories include a Vinten heavy-duty Quickfix adaptor (part no. 3490-3) that allows

operators to easily and quickly mount and remove the head from a pedestal or tripod, and an

intermediate plate (part no. 3384-11) used to raise the camera on the camera cradle, thereby

adjusting the camera C of G height. For more information refer to the Parts list on page 40.

Mounting the head

All variants of the FH-100 head have a standard Vinten four-hole mounting plate that is

compatible with the Vinten Quickfix base. The head can be mounted directly onto a pedestal,

typically a Fusion FP-188 pedestal, an FPH-188 height drive or a Vinten heavy-duty tripod.

Place the head onto the pedestal or tripod mounting plate ensuring that the head cannot fall.

Secure with the four fixing bolts and washers supplied, then use the Vinten spanner to tighten

the fixing bolts.

Fig. 4 Standard accessories

CAUTION! Hold a fixing bolt in position thought the mounting plate and ensure that

the threaded end does not project more than 12 mm (0.47 in.) above the

mounting plate face.

CAUTION! Risk of damage to the product – Do not overtighten the fixing bolts.

Vinten spanner

Washers (4 off)

Head fixing bolt (4 off)

Part No. J551-001

Part No. L602-122

Part No. L054-714

Telescopic pan bar (2 off)

Part No. 3219-91