User Manual

21
Adjustments
To enable the payload to be correctly balanced, the EFP Quickfix adaptor may require reposition-
ing.
The following adjustments may be necessary after prolonged use:
The platform slide clamp may require adjustment.
The pan and tilt brakes may require adjustment.
Repositioning the EFP Quickfit adaptor
The EFP Quickfit adaptor (2) is secured by six screws (18) which pass through the adaptor into
the sliding plate (27). The EFP Quickfit adaptor may be fitted in three positions.
To reposition the EFP Quickfit adaptor:
Engage the centre lock (see Locking the platform on page 13) and remove the payload.
Hold the body of the EFP Quickfit adaptor (2) and remove the six securing screws (18).
Reposition the Quickfit adaptor (2) on the sliding plate (27), ensuring that the lock bar (4) is
towards the rear.
Insert the six screws (18) in the holes in the adaptor and tighten.
WARNING! Overlong screws will prevent the sliding plate from operating.
Always use the screws provided (M4 x 12 mm).
Platform slide clamp adjustment
(20.1)
(20.2)
(20)