User Manual

22
Platform slide clamp adjustment
The platform slide clamp should be set so that, in the up or clamped position it prevents the plat-
form slide from being moved, while in the down or released position it allows free adjustment of
the slide. To adjust the clamp, proceed as follows:
Pull the slide clamp lever (20) fully upwards.
Slacken the clamp screw (20.2).
Turn the slotted shaft (20.1) fully clockwise to apply the clamp.
Tighten the clamp screw (20.2).
Move the lever (20) over its full range and ensure that, in the clamped position, it prevents
the slide from being moved, while in the released position it allows free adjustment of the
slide. Re-adjust if necessary.
Pan and tilt brake adjustment
The pan (10) and tilt brakes (9) are operated by levers on the right of the head. The brakes are
applied by pushing the appropriate lever down and released by pulling the lever up.
If the brakes become ineffective, adjustment should be carried out by qualified personnel in ac-
cordance with the Maintenance Manual (Publication Part No. 3805-9).