User Manual

1. Lift lever
2. AUX IN jack
3. 33/45/78 RPM switch – This switch controls the RPM of the turntable platter.
4. Mode selection knob
5. AUTO STOP ON/OFF switch
6. Power on/off and volume control knob
7. Headphones jack —to connect headphones or earphones to enjoy music privately
8. Cartridge
9. Tone arm clip
10. Platter – Place your record here.
11. 45 RPM adapter –used for 45RPM vinyl records
12. Hinge
13. RCA output – Used to connect to external speakers (not included)
14. DC port – Used to connect power adapter
PHONO MODE---VINYL RECORD PLAYBACK
Turn the mode selection knob to PH/LINE IN.
(Remark: please make sure that the AUX IN jack is not plugged in with any cable)
1. Connect the power adapter to the unit and mains socket.
2. Turn the power & volume control knob clockwise.The indicator light will illuminate red.
4. Place a record on the turntable platter and select the desired speed (33/45/78)
according to the record.
NOTE: when playing a 45 rpm record, use the included 45 rpm adapter located in the
holder near the tone arm.
5. Open the tone arm clip to release the tone arm. Push the lift lever backward to raise the
tone arm and gently move the tone arm to the desired position over the record.
Push the lift lever forward to lower the tone arm slowly onto the desired position on the
record.
6. AUTO STOP feature applies to most 33RPM vinyl records.
If the AUTO STOP ON/OFF Switch is turned ON, the record will stop automatically when
finished(For some few vinyl records, it will stop when it does not come to the end or it will not
stop when it comes to the end). If Auto Stop Control is turned OFF, record will NOT stop
automatically when finished.
LINE IN MODE
1. Connect your iPod, MP3 player, mobile phones etc. to the AUX IN port with a