Owner`s manual

Viola Cadenza Manual Rev 1 Page 4 of 16 7th September 2005
INTRODUCTION
Thank you for choosing the VIOLA Cadenza Preamplifier. Great care has gone into
the design and manufacture of the Cadenza and if properly used, it will give a
lifetime of musical enjoyment. We strongly recommend that you read these
instructions before you attempt to use the unit, so that you can be sure it is set up to
give optimum performance.
UNPACKING
Please keep all of the packing materials in case you ever need to ship the unit.
Should you need to return the unit to the factory, you must use the original shipping
carton. The use of any other packing may result in the product sustaining damage in
transit. Such damage is not covered by the warranty. Replacement shipping cartons
may be obtained via your VIOLA dealer, national distributor or directly from the
factory.
After unpacking the unit, please confirm that the following items are present:
1 VIOLA Cadenza preamplifier
1 VIOLA Cadenza preamplifier power supply
1 DC supply cable
1 three-conductor mains cord
1 user manual
If any of the above items are missing, or if the units show any signs of damage,
please contact your VIOLA dealer immediately.
VOLTAGE SETTING
Before going any further please, confirm that the unit is set to operate on the mains
voltage you plan to use. The setting is indicated on the fuse cover on the mains
input receptacle, which is located on the power supply rear panel. In the example
shown in figure 1 below, the unit has been set to operate from 120V.
Figure 1. Cadenza power supply mains inlet receptacle.
100
120
V
230
V
240
V
USE ONLY WITH
250V FUSES
0
1