%/! 22" HD LCD Television with Built-in DVD Ployer LCD22VH65 AIR (TV)/CABLE MODE SELECTION The Air/CABLE menu option is set to the "CABLE" (Cable Television) mode at the factory. If you want to use an antenna for the built-in TV tuner, this menu option must be set to the "Air" mode. Please refer to "6. Channel MENU" in page 16 of this manual for the details.
Contents Contents 2 Caution 3 Safety Information 4 Unit and Accessories 4 Product 4 Feature Introduction 5-7 1. Front View 5 2. Rear View 6 3. Remote Control 7 Connection 8-10 Basic 11 Ope-ration OSD Menu 1. Picture 2. Audio 11-17 menu 11 menu 12 3. Time menu 12 4. Setup 13 menu 5. P.G menu 6.
Caution The lightening flash with arrowhead symbol, within an equilateral triangle is intended to alert the user to the presence of un-insulated "dangerous voltage" within the products enclosure that may be of sufficient magnitude to constitute a risk of electric shock to the persons. The exclamation point within an equilateral user to the presence of important operating instructions in the literature accompanying triangle is intend to alert the and maintenance (servicing) the appliance.
Sa et In brmadon Safety Information To ensure reliable and safe operation of this equipment, please instructions in this user guide, especially the safety information Electrical read carefully below. all the safety -The TVset should only be connected to a mains supply which matches that stated on the label on the mains adaptor -To prevent overload, don't share the same mains supply socket with too many other items of equipment. 1.
Unit and Accessories and Product Feature unit anO Accessories TV set m_ii UserU$ Mahua| iJ @ 0 _i ii User's manual Product Remote control Batteries: 2xAA Feature - Inputs: RF, VIDEO, VGA, YPbPr, HDMI - DVD slot -Audio Input:AVAudio R/L, PC Audio - Support TV mode: NTSC-M,ATSC - Search TV: Auto/Manual - Auto-shutting down - Program exchange and edit -Support QAM and 8VSB demodulation -4-
Introduction introduction , Front View j-.. f= '\_ sou_cEi SOURCE k _ J MENU i F_ '\ _ CH_ MENU CH+ Fm _J IL _ i c. ½_ CH j voL, \ 1: Remote 2: Indicator control sensor. LED: GREEN RED POWER ® ON. STANDBY. The effective receiving range for the signal is 5-8 metres from the front of the remote control window, and 300 to the left or right side and 20 o above or below the remote control window 3: Key board 1). SOURCE: Display the input source menu. 2). MENU: Display main MENU. 3).
Introduction 2 Rear View QTf" 1.AC POWER INPUT 2. HDMI INPUT 3, VGAINPUT 4. PC AUDIO INPUT Note: 1.AV, S-VlDEO 5. AV/S-VlDEO AUDIO INPUT 6. REARAUDIO INPUT 7. YPbPr INPUT 8.ANT and YPbPr share the Rear Audio input channel. 2. When HDMI port get DVl signal,the the audio from HDMI port. PC Audio channel will change to receive Wall Mounting The TV is provided with mounting holes for a VESAapproved wall mounting bracket.
REMOTE CONTROL 1 :POWER ii @ @ @ @ @ @ @ @-@ @@@@ 000e i@ } @@@@ Insert Batteries Into the Remote Control 1. Remove the battery cover. 2. Inserting the 2 AAA 1.
Connection Connection Power Cord Connection - Connect the power cord to a wall outlet as shown, and turn the switch (Page 6) on. - When you connect the power, the TV set comes into standby mode and the LED indicator (Page 5) lights red.
Connection Antenna cabJe connection AV Input ConnectionNote:AII cables shown are not included with the TV. RCAAudio Cable V j" \ DVD YPbPr Connection Note: All cables shown are not included or VCR with the TV.
Connection HDMI Connection Note:All cables shown are not included ................................................ _ _ v _,62!4_.................................. _ ........................... _ with the TV. .................... [,_?F ?_Tf'_T................................................................................................................ V DVD or VCR .................. r ,_ooo i PC Connection Note: All cables shown are not included with the TV.
Basic 0 eration Basic OSD Menu operation Press MENU button to display the OSD Use4i_ button to select the main menu, and press v button to enter the submenu.ln the submenu, useVAbutton to select the function item, and you could:adjust ("Contrast" item in Picture menu for example) with_l_ button; select ("Picture Mode" item in Picture menu for example) with4t, button; enter the submenu ("Close Caption" item in Setup menu for example) with) button. * (Press MENU button to return to the upper menu.
OSD 2.Audio Menu menu Description Sound Mode: Select your desired sound mode as follow: Standard, Music, Movie, And personal. You may select the sound mode directly by pressing the SOUND Button on the remote control. Bass: control the intensity of low frequencies. Treble: control the intensity of high frequencies. Balance: Left and right stereo audio channels balance. Surround: Activate or deactivate the Surround function. AVC: Auto volume control. Spdif Type: Spdif output format select.
OSD Menu 4. Setup menu Description Menu Language: Select OSD menu language. Transparency: Turn on or off the transparency menu function. Aspect: Select the aspect mode between 16:9, Zoom, Cinema and Normal. Noise reduction: Select the noise reduction mode between Strong, Off, Weak and Middle. PC SETUP: If the video input signal comes from your PC, you may adjust the V-Position, H-Position, Clock, Phase or even perform an Auto adjustment.
OSD 5. P.G menu You must enter the password to gain access 6666. You may modify the following options: Menu to the P.G menu. The default password is L?®so¢_Sfo# Change password: Change the password, you must enter the new password twice to confirm it. Note: Do not forget the password. P.G Switch: Allow you to turn on or off the system lock. If deactivated, the functions described below don' t work. This option menu allows you to lock any TV channel or adjust the Movie rating filter.
OSD Menu MPAA: The Movie rating (MPAA) is used for original movies rated by the Motion Picture Association of America (MPAA) as broadcasted on cable TVand not edited for television. UseA_button to select N/A, G, PG, PG-13, R, NC-17 or X. Description G PG Age PG-I_ Restrict. Under 17 requires accompanying guardian(age varies in some jurisdictions) R NC-17 X General audiences, All Ages admitted Parental Guidance suggested. Some material may not be Suitable for children. Parents strqnqly cautioned.
OSD 6. Channel menu L_esor_p#on Air/Cable: Allow you to select antenna between Air and Cable. If you selet Auto Scan: Enter the Auto Scan menu to start auto scan. If you select "Air" or "Cable" as input signal in Antenna item, you can press _button to search the channels automatically. The receivable channels will be stored automatically. When searching channels, press MENU to stop. NOTE: It will take a while to auto scan in NTSC orATSC mode, please wait patiently.
OSD Menu Show/Hide:Allow you to show or hide the channels. Use_,_'button to highlight the desired item, then press OK button to show or hide the highlighted channel. Channel No.: Show and select the channel. Channel Label: Allow you to setup a label for the channel. Press ,_T button select the position of the table, and press4_button to select the words. DTV Signal: Show the quality of digital signal: -17- good, Normal, Bad.
D VD OPERA TION Features Disc formats supported MPEG-# Caution MPEG4 files on disc The DVD video player is A class t laser product. Use of controls or adjustments or performance of procedures other than those specified herein. May result in hazardous radiation Exposure. As the laser beam used in this DVD video player. Is harmful to the eyes, do not attempt to disassemble the Cabinet. Refer servicing to qualified personnel only.
DVD OPERATION l. GeneraIStepsofsetupmenu A) Press the setup appears. button, 2. the main setup Setup items introduction menu 2.1 SYSTEM The system 2.1.1 SETUP setup options are illustrated TV SYSTEM According to the Color System can choose the TV System. B) Press the Left and Right arrow highlight the iconofthedesired below: of the TV, you buttons to page, then press the Down or Right arrow button to activate that page.
DVD OPERATION 2.1.4 PASSWORD 2.2 LANGUAGE SETUP The password option is initially locked, and you can not set the ratings limit or change the The language password. In order for the Ratings feature to work, the password mode must be turned on. If you want to set the ratings limit, you will need Highlight to enter the default password. Which is 6666. then press Enter to confirm. To change the password, you will be prompted for the old and it will display OSD in that language.
DVD 2.2.3 2.4 SUBTITLELANG Highlight the SUBTITLE press the Arrow buttons VIDEO The video LANGoption, and to choose the subtitle OPERATION SETUP setup options are illustrated below: language you prefer. Press Enter to confirm. If the disc you are playing has that language available, it will display subtitles in that language. Note: The SUBTITLE LANGUAGE is subject to sales country.. display 2.4.1 BRIGHTNESS Use the Up and move the scroll 2.2.
DVD 2.4.3 2.4.4 2.5 HUE Use the Up and Down arrow buttons the scroll and adjust the hue. to move SPEAKER SETUP The speaker setup options are illustrated below: 2.5.1 DOWNMIX A)LT/RT Choose this setting when theDVD player is connected toa2Channel Analog Audio input. B)STEREO Choose this setting when the DVD player is connected toaTVor therefore modulator. SATURATION Use the Up and Down arrow buttons the scroll and adjust the saturation. to move 2.
DVD _ 0-9 @_ keys • These keys are used to input the time, as well as title, chapter and track numbers. • When a numeric item is displayed on the screen, press the 0-9 keys to select the desired and press ENTER to confirm. entry, • When a numeric item is larger than 9 press GOTO key to select the display entry.
O% GOTO During pmayback, press GOTO show current time counter position. DVD REMOTE @_;' PREV Press the O CONTROL OPERATION PREV to skip to previous _::_ playback, press DISPLAY time counter position. Enter number to choose the Play time. to choose Chapter DVD/USB Switch O between Total Chapter Current Disc type Current O'_ to show the Play time of the current title Total Chapter Enter number the Chapter. or track.
DVD OPERATION Mp3 PLAYBACK When a MPEG and a Mp3 disc is loaded, the screen will be displayed as follows: Current Current MP3/JPEG File Switch the file type and The p}aying file is a Mp3 audio file. PresgG-O Press the Region: of the Displays p}aying switching. The p}aying file is a JPEG picture fi}e. to select the file when the cursor select to play the current PressC:ll:_ file name, If a JPEG file is being played, the name should have a JPEG extension.
DVD Trouble shooting If you have any questions, ® Ensure the power button ® Ensure the power outlet • please consult the troubleshooting guide below: is on. Make sure the Main unit s POWER is operational. Ensure the power cord is not damaged. ® Ensure the power plug is connected ® Ensure the remote ® Point the remote batteries control button is on are working. directly at the player between the remote firmly to the outlet. ® Turn off the power, and then turn it on again.
Viore,lnc.
