User guide

Chapter 15: Deinterlacer MegaCore Function 15–13
Signals
January 2013 Altera Corporation Video and Image Processing Suite
User Guide
din_valid In
din port Avalon-ST valid signal. This signal identifies the
cycles when the port must input data.
dout_data Out
dout port Avalon-ST data bus. This bus enables the
transfer of pixel data out of the MegaCore function.
dout_endofpacket Out
dout port Avalon-ST endofpacket signal. This signal
marks the end of an Avalon-ST packet.
dout_ready In
dout port Avalon-ST ready signal. The downstream device
asserts this signal when it is able to receive data.
dout_startofpacket Out
dout port Avalon-ST startofpacket signal. This signal
marks the start of an Avalon-ST packet.
dout_valid Out
dout port Avalon-ST valid signal. The MegaCore function
asserts this signal when it outputs data.
ker_writer_control_av_address In
ker_writer_control slave port Avalon-MM address
bus. This bus specifies a word offset into the slave address
space.
(6)
ker_writer_control_av_chipselect In
ker_writer_control slave port Avalon-MM
chipselect signal. The ker_writer_control port
ignores all other signals unless you assert this signal.
(6)
ker_writer_control_av_readdata Out
ker_writer_control slave port Avalon-MM readdata
bus. The MegaCore function uses these output lines for
read transfers.
(6)
ker_writer_control_av_waitrequest Out
ker_writer_control slave port Avalon-MM
waitrequest signal.
(6)
ker_writer_control_av_write In
ker_writer_control slave port Avalon-MM write
signal. When you assert this signal, the
ker_writer_control port accepts new data from the
writedata bus.
(6)
ker_writer_control_av_writedata In
ker_writer_control slave port Avalon-MM writedata
bus. The MegaCore function uses these input lines for write
transfers.
(6)
ma_control_av_address In
ma_control slave port Avalon-MM address bus. This bus
specifies a word offset into the slave address space.
(5)
ma_control_av_chipselect In
ma_control slave port Avalon-MM chipselect signal.
The
ma_control port ignores all other signals unless you
assert this signal.
(5)
ma_control_av_readdata Out
ma_control slave port Avalon-MM readdata bus. The
MegaCore function uses these output lines for read
transfers.
(5)
ma_control_av_waitrequest Out
ma_control slave port Avalon-MM waitrequest signal.
(5)
ma_control_av_write In
ma_control slave port Avalon-MM write signal. When
you assert this signal, the
ma_control port accepts new
data from the
writedata bus.
(5)
ma_control_av_writedata In
ma_control slave port Avalon-MM writedata bus. The
MegaCore function uses these input lines for write
transfers.
(5)
Table 15–4. Deinterlacer Signals (Part 2 of 4)
Signal Direction Description