Installation guide

multi-level security arming

Multi-Level Security Arming is a feature that allows the user to select which of the system's inputs or sensors

will be active and which will be bypassed when the system is armed. (See Table of Zones section of this guide.)

Multi-Level Security Arming can only be accessed from a standard configuration transmitter. Pressing the arm

button of the standard configuration transmitter again within five seconds of arming the system will activate the

Multi-Level Security feature. Each time the arm button is pressed again, a different security level is selected. The

different levels of security are selected as follows:

■ Pressing one time: The siren chirps once. The system is armed.

■ Pressing a second time within five seconds: The siren chirps twice followed by a long chirp. Zone

Two is now bypassed.

■ Pressing a third time within five seconds: The siren chirps three times followed by a long chirp. Zone

Four is now bypassed.

■ Pressing a fourth time within five seconds: The siren chirps four times followed by a long chirp.

Zones Two and Four are now bypassed.

■ Pressing a fifth time within five seconds: The siren chirps five times followed by a long chirp. All

input zones, except the ignition, are now bypassed.

system features learn routine

The System Features Learn Routine™ dictates how the unit operates. Due to the number of features, the

features have been divided into two menus. It is possible to access and change any of the feature set-

tings using the Valet®/Program switch. However, this process can be greatly simplified by using the Bitwriter™.

Any of the settings can be changed and then assigned to one of up to four transmitters, a feature called Owner

Recognition. Each time that particular transmitter is used to disarm the system, the assigned feature settings

will be recalled. Owner Recognition is only possible when programming the unit via the Bitwriter.

The learn routine may be locked if previously programmed using the Bitwriter. If the horn generates one

long honk when attempting to program the unit, the learn routine is locked and must be unlocked using

the Bitwriter™ before proceeding.