Installation guide

11
locations for the relay satellite
The relay satellite wiring carries large amounts of current. The wires should not be extended and should be
cut to the minimum length necessary. Since the relay satellite is functioning as the ignition switch in the
vehicle, it is often convenient to mount the relay satellite close to the main ignition switch harness.
finding the wires you need
Now that you have decided where each component will be located, you’re going to find the wires in the car
that the security system will be connected to.
IMPORTANT! Do not use a 12V test light or logic probe (computer safe test light) to find these wires! Use
a digital multimeter for all testing.
obtaining constant 12V
We recommend two possible sources for 12V constant: the (+) terminal of the battery, or the constant supply
to the ignition switch. Always install a fuse within 12 inches of this connection. If the fuse also will be
powering other circuits such as door locks, fuse accordingly.
IMPORTANT! Do not remove the fuse holder on the red wire. It ensures that the control module has its own