Installation guide

H1/7 BLUE (-) multiplex input, zone 4

Inputs shorter than 0.8 seconds will trigger the Warn Away response, while inputs longer than 0.8 seconds

will trigger the full alarm sequence. If installing an optional Directed Electronics dual stage sensor, connect

both the blue and the green wires of the optional sensor to this input. This wire will report Zone 4.

H1/8 GREEN (-) door trigger input, zone 3

Most vehicles use negative door trigger circuits. Connect the green wire to a wire which shows ground when

any door is opened. In vehicles with factory delays on the domelight circuit, there is usually a wire that is

unaffected by the delay circuitry. This wire will report Zone 3.

H1/9 BLACK/WHITE (-) 200 mA domelight supervision output

Connect this wire to the optional domelight supervision relay as shown below:

IMPORTANT! This output is only intended to drive a relay. It cannot be connected directly to the domelight

circuit, as the output cannot support the current draw of one or more light bulbs.