Installation guide

© 2006 Directed Electronics—all rights reserved
57
extra parts for unlock and lock outputs (see below).
2-8 LOCK OUTPUT—1, 2 PULSES: This will program the lock output to one or two pulses. When the double
pulse lock feature is turned on, the BLUE door lock harness wire will supply two positive pulses instead of
a single pulse. At the same time, the GREEN door lock harness wire will supply two negative pulses instead
of a single pulse.
2-9 FACTORY ALARM DISARM WITH CHANNEL 2: In the default setting the factory alarm disarm output will
disarm the factory alarm system any time the button(s) controlling Channel Two is pressed.
2-10 FACTORY ALARM DISARM—WITH UNLOCK, BEFORE UNLOCK, REMOTE START ONLY: In the default setting
the factory alarm disarm output will disarm the factory alarm system any time the button(s) controlling Unlock
is pressed. The “Before Unlock” output to disarms the factory alarm before the unlock output activates and
before remote start is activated. The “Remote Start Only” output disarms the factory alarm only before the
remote start is activated.
2-11 FACTORY ALARM DISARM PULSES—SINGLE, DOUBLE: Selectable for a single or double-pulse for the
vehicle’s factory alarm disarm input requirements.
2-12 CHANNEL 4 VALIDITY/LATCHED/LATCHED RESET WITH IGNITION/30 SECOND TIMED OUTPUT: This
wire provides a (-) 200mA output whenever the remote control button(s) controlling Channel 4 is pressed.
This output can be programmed to provide the following types of outputs (see also the Feature Menus
section):
■ Validity: Output that will send a signal as long as the transmission is received.
■ Latched: Output that will send a signal when the Channel 4 button(s) is pressed and will continue until
the same button(s) is pressed again.
■ Latched, reset with ignition: Similar to the latched output, this type of output turns on the first time
the Channel 4 button(s) is pressed and turns off the next time the same button is pressed. This type of
output additionally stops and resets whenever the ignition is turned on and then off.
■ 30-second timed: Output that will send a continuous signal for 30 seconds.
Note: All auxilary channel timed outputs can be programmed using the Bitwriter® (1-90 seconds).
2-13 CHANNEL 4 LINKING (NONE)/ARM, DISARM, REMOTE START: When programming to validity or timed
output this can be programmed to activate when arming or disarming (or remote start) with the remote
control.
2-14 CHANNEL 5 VALIDITY/LATCHED/LATCHED RESET WITH IGNITION/30 SECOND TIMED OUTPUT:
Channel Five can be programmed for these output configurations. The unit is set to the default validity
output. To change the configuration, use the two-chirp setting to toggle through the different configura-
tions. Refer to feature 2-10 for additional detail.
2-15 CHANNEL 5 LINKING (NONE)/ARM, DISARM, REMOTE START: Refer to feature 2-13 for additional
detail.
2-16 CHANNEL 6 VALIDITY/LATCHED/LATCHED RESET WITH IGNITION/30 SECOND TIMED OUTPUT: