User manual

USER MANUAL ENGLISH
OPERATION OF FOAM GENERATOR
BASIC OPERATION
Please follow the instructions to achieve the top performance.
1] Installation:
a. Set Viper VE Model Polishers (A) at the up-right position and install 2 sets Accessory Clamp (C) on the tube of polisher.
b. Install the Foam Generator (B) on the polisher.
b1. Put the ends of Bracket (D) in the slot of Accessory Clamp (C).
b2. Fasten the Knob (E) and lock up the Accessory Clamp (B)
b3. Connect the Foam Outlet Hose (F) to the fitting on the polisher.
b4. Connect the Power Supply Cord (G) to the socket on the polisher rear handle housing.
2] Solution:
Mix the Viper “508” carpet cleaner with water (Ratio 1:15). Pour into the Solution Inlet (5) gently.
NOTE
Solution tank capacity is 6 Liters.
3] Carpet Cleaning:
Set the polisher in working position (lowering the handle). Turn the Foam Adjusting Knob (4) 180e, wait for 3-5 seconds, adjust the
Foam Adjusting Knob (4) for desired foam volume. Turn the Foam Adjusting Knob (4) to 0 position to switch off the machine.
NOTE
DO NOT turn on the Polisher until seeing the foam coming out of the shampoo brush.
14019E (1) 2010-12 A DF-100A-EU 9