User Manual GV25-EU GV35-EU GV702-EU english deutch francais nederlands italiano espanol portugues User Manual……………………………………………1-11 Betriebsanleitung……………………………………… xxx Notice d’utilisation …………………………………….. xxx Gebruiksaanwijzing……………………………………. xxx Istruzioni sull´uso………………………………………. xxx Instrucciones de manejo……………………………… xxx Instruções de operação……………………………….. xxx Company information: WWW.vipercleaning.eu info-eu@vipercleaning.
USER MANUAL ENGLISH TABLE OF CONTENTS INTRODUCTION ................................................................................................................................................................. 2 MANUAL PURPOSE AND CONTENTS .......................................................................................................................................... 2 TARGET........................................................................................................................
ENGLISH USER MANUAL INTRODUCTION (CAUTION: Read the instruction manual before using the appliance) NOTE The numbers in brackets refer to the components shown in Machine Description chapter. MANUAL PURPOSE AND CONTENTS The purpose of this Manual is to provide the operator with all necessary information to use the machine properly, in a safe and autonomous way. It contains information about technical data, safety, operation, storage, maintenance, spare parts and disposal.
USER MANUAL ENGLISH CHANGES AND IMPROVEMENTS VIPER constantly improves its products and reserves the right to make changes and improvements at its discretion without being obliged to apply such benefits to the machines that were previously sold. Any change and/or addition of accessories must be approved and performed by VIPER.
ENGLISH USER MANUAL GENERAL INSTRUCTIONS Specific warnings and cautions to inform about potential damages to people and machine are shown below. – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – DANGER! Always disconnect the power supply cable when the machine is not in use, before performing maintenance procedures and before replacing parts or converting the appliance to another . This machine must be used by properly trained and authorised personnel only.
USER MANUAL – – – – – – – – – – – – – – – – – – – – ENGLISH The humidity must be between 30% and 95%. Do not use the machine as a means of transport. Do not use the machine on slopes with a gradient exceeding the specifications. In case of fire, use a powder fire extinguisher, not a water one. Do not tamper with the machine safety guards and follow the ordinary maintenance instructions scrupulously. Do not allow any object to enter into the openings. Do not use the machine if the openings are clogged.
ENGLISH USER MANUAL MACHINE DESCRIPTION MACHINE STRUCTURE( (GV25-EU GV35-EU) ) 1. 2. 3. 4. 5. Handle Cover Mains cord Catch Tank 6. Caster 7. Mounting base 8. Intake 9. On/off switch MACHINE STRUCTURE( (GV702-EU) ) 1. 2. 3. 4. 5. 6. 7. 8. Carring handle On/off switch Top cover Tank Intake Outlet Handle lift Mounting base 9. Castor 10. Wheel 11. Support 12. Clamp 13. Catch 14. Handle 15. Mains cord 16.
USER MANUAL ENGLISH STANDARD ACCESSORY SET (GV25-EU GV35-EU) 1. 2. 3. 4. Wet pick-up tool (300mm) Crevice tool Combination tool Tube 2 5. Hose 6. Upholstery tool 7. Dusting tool 4 4 3 5 1 7 6 STANDARD ACCESSORY SET (GV702-EU) 1. 2. 3. 4. 5. Combination tool Upholstery tool Dusting tool Crevice tool Tube 6. 7. 8. 9.
ENGLISH USER MANUAL WIRING DIAGRAM FOR GV25-EU GV35-EU SWITCH 220V 50/60HZ SINGLE PHASE SUPPLY EMI BROWN BROWN BLUE BLUE G/Y G/Y Motor H05RN-F 3X0.
USER MANUAL ENGLISH OPERATION OF VACUUM CLEANER BASIC OPERATION 1. Check that the electrical switch is switched off, 2. Then connect the suction hose (1) into the suction inlet (2) at the machine by pushing the hose forward until it is sliding in place at the inlet (to release the hose from machine just twist and pull out the hose). 12 3. Then connect the tubes (1) with the hose handle (2), twist the tubes in order to ensure that they are properly fitted. 4.
ENGLISH USER MANUAL 3 2 1 1 2 3 4 6 3. Empty by tilting the container (1) backwards and pour the liquids into a floor drain or similar. 4. Wipe float valve (2), filter (3) and the motor top with a damp cloth before the motor top is reinstalled to the container. 5. Replace the float valve assembly and power head. Secure with the latches. Emptying GV702-EU 1.
USER MANUAL ENGLISH STORAGE 1] Unplug machine from power source. 2] Store in upright position in a dry area. Do not dispose of electrical appliances as unsorted municipal waste, use separate collection facilities.